Follow the hoses from your nozzles that clean windsheild, pump is usally part of the motor.
My Question is:How do you AsembleandDisassenbleAWindshield washer motorfor a1991 Chevy S-10?Is there a Diagram Available on line?Thanks a lot
You could try to use "jumper" wires from a 12volt battery if it doesnt move them the motor is bad. If it does then the relay\fuse or switch is bad. Hope this helps you.
no
The wiper motor is mounted on the left inside of the windshield frame on the same bracket as the VIN. Fold down the windshield and is fully accessible.
Try using a guitar string
I doubt it
Yes it will.
MOTOR FOR WIPERS
To access the wiper motor on a 1991 Chevy van, first, open the hood and remove the wiper arms by loosening the nuts at their bases. Next, take off the plastic cowl cover that sits between the windshield and the hood by removing the screws or clips holding it in place. Once the cover is removed, you can see the wiper motor, which is usually mounted on the firewall; disconnect the electrical connector and unbolt the motor to replace or repair it.
the windshield wiper motor could be getting Hot! Mine does the same thing, then when it cools off they work again.
You can try Quadratec.com, Rockauto.com, or your local jeep dealer
No there is not 2 filters.