Want this question answered?
The starter on a 1998 GMC Sonoma is replaced by disconnecting the battery, removing the outer cover, and unbolting it from the engine. The wiring harness can then be disconnected, the starter removed, and a new one put in place.
The wiring harness for the radio in a 1991 GMC Pickup is going to be behind the radio. The wiring harness is plugged into the back of the radio. The fuse for the radio is in the fuse box located on the driver's side below the dashboard.
Removal of the cooling fan on a 2002 GMC Sonoma 4.3l begins with disconnecting the battery, removing the wiring harness to the fan, and taking off the protective shroud. The fan can then be unbolted from the frame and removed.
were is csp on gmc sonoma 2.2
where is the iat sensor located on a 2003 gmc sonoma truck
You can find a radio wiring diagram for a 1993 GMC Sonoma in the vehicle's owner's manual. You can also find it at local auto parts stores.
The brake controller wiring harness connector for the 2005 GMC Envoy is located under the dash on the driver's side of the vehicle. Look for a connector plug not connected to anything, next to the hood release latch.
Under
Where are the freeze plugs located on a 2003 GMC Sonoma 4.3L Vortec engine?
The MAP Sensor on the GMC Sonoma is located in the engine compartment just to the left of the alternator. The MAP Sensor is usually colored silver or shows a gold tint.
No, a 95 GMC Sonoma does not use a timing belt on it. The 95 GMC Sonoma uses a timing chain on it.
Should be under the hood on the pasenger side.