0
What else can I help you with?
Where is the engine oil drain plug on a 2008 harley Davidson ultra classic?
Where are the drain plugs for engine, transmission, etc and can the same oil be used for all three compartments
Where is the transmission drain plug on 2008 Chevy impala 3.5liter?
It does not have one. You will have to remove the transmission fluid pan to drain the transmission.
Where is the oil drain plug on a 2008 Harley Sportster?
it's underneath the oil tank carol,tell mark to take off his dress and do it himself
Can you use the same synth oil viscosity in both motor tranny harleydavidson 2008?
I understand you can use the same oil viscosity in both motor & transmission on the 2008 harley roadking!
Where is the speed sensor on a 2008 harley dyna?
On a 2008 Harley Dyna, the speed sensor is typically located on the transmission. It is mounted on the top of the transmission case, near the output shaft. To access it, you may need to remove the primary cover or other components, depending on the specific model and any modifications. Always refer to the service manual for precise instructions and safety precautions.
Where is the condenser drain in 2008 tundra?
The ac condensation drain is located at the bottom center of the firewall, directly above the transmission on the 2008 Toyota Tundra (5.7 Force 6-spd automatic). It is not a tube but a 2-inch (approx) grommet-type opening that deposits the condensation onto the top of the transmission.
When did Harley Dickinson die?
Harley Dickinson died in 2008.
Where is the AC condenser drain in 2008 tundra?
The ac condensation drain is located at the bottom center of the firewall, directly above the transmission on the 2008 Toyota Tundra (5.7 Force 6-spd automatic). It is not a tube but a 2-inch (approx) grommet-type opening that deposits the condensation onto the top of the transmission.
How do you change transmission gearbox oil fluid on 2008 Toyota Previa?
To change the transmission fluid on a 2008 Toyota Previa, start by warming up the vehicle to ensure the fluid flows easily, then lift the vehicle and secure it on jack stands. Remove the transmission drain plug to drain the old fluid into a suitable container. After allowing it to fully drain, replace the drain plug and refill the transmission with new fluid through the fill plug using a funnel, ensuring to use the correct type of transmission fluid specified in the owner's manual. Finally, check the fluid level with the engine running and the transmission in park, adding more fluid if necessary.
Where is the transmission drain plug in a 2008 Ford Fusion?
In a 2008 Ford Fusion, the transmission drain plug is typically located on the bottom of the transmission pan. To access it, you may need to raise the vehicle and remove any protective coverings. It's important to ensure the vehicle is securely supported before attempting any maintenance. Always consult the owner's manual or a repair guide for specific details regarding your vehicle's transmission.
What is the transmission fluid capacity for a 1993 Mercury Sable?
It's about 14 quarts of transmission fluid, but you can't drain it all unless you're flushing it, so expect to be able to drain (and replace) about 5 quarts. RFischer McLean, VA Dec 28, 2008
Where is the oil drain and fill plug on a Ford 2008 escape with a cylinder with a manual transmission?
On a 2008 Ford Escape with a manual transmission, the oil drain plug is located on the bottom of the transmission case, typically towards the rear. The fill plug can usually be found on the side of the transmission, often near the top. To access these plugs, you may need to lift the vehicle and ensure it is securely supported. Always refer to the owner’s manual for specific locations and torque specifications.
