0
What else can I help you with?
How fast should a tire with a nail in it be replaced?
As soon as practical. It will have a slow leak until it is replaced. Don't remove it! Your tire will go flat and you will be stuck.
Can you put a 19.5 tire on a 20 inch rim?
NO ! -Tires must always go on the correct rim.
Why would your car only shake really bad at 33MPH to 37MPH?
cause your intake valve is bent You probably have a bad tire or rim. I'd go with the tire or rim answer.
What is the 2004 f-250 tire size?
just go to a tire shop. But the normal rim size is 16 and tire can change size.
What kind of tires go on the stock rim of a 1994 Impala SS?
If you look on the inside of the drivers door by the door latch you will see the size tire it should have, the make of tire I don't know.
Can a 16 tire with inner-tube fit a 15 wheel?
No. A 16" tire must go on a 16" wheel (rim).
What is the math for figuring out the tire and rim size combination for your car when you want to buy larger rims than what was stock for the car.?
Go to discounttire.com. There you'll find tire and rim combinations plus information on tire/wheel combinations. In short, the larger the rim diameter, the smaller the radius of the tire, to compensate for the additional sizes. For instance, a new Mustang with stock factory 15" wheels can go as large as 18" wheels with the right tire.
You have a 94 Honda Accord and the floor and seat of the driver's side vibrates at hgwy speeds you just replaced axel ball joints CV boot tires balanced and aligned Any ideas why?
I would look for a tire that is out of round or a bent wheel. I would place each one on a balancer and watch the horizon of the tire for a out of round condition. Do the same for a possible bent rim. You see, you can balance a bent rim and a out of round tire...This should have been caught at that time. If your shop seems unresponsive to this, go to a different shop.
Can you fit your 700 28c bicycle tire to a 700 23c?
Any rim that can take one 700C tire will take any other 700C tire, after a fashion. But just because the tire will fit the rim doesn't guarantee that the tire will fit in the frame or fork. 23C to 28C isn't much of a difference, but if you go crazy wide there's a risk that the wider tire won't sit that well on a narrow rim.
Can a 10 inch tire fit on a 7 inch rim?
You must know the answer is NO. Not necessarily true, we're talking about width I assume, the section width of the tire 10" in this case is measured at the widest part of the tire. The bead, the part of the tire that sits on the wheel, is significantly narrower. Just as an example P245/55R20, which is a 10" wide tire lists the apporved rim width as 7.0"-9.0", so depending on the exact size it is very possible that your 10" wide tire could go on a 7" wide rim.
How do you mount tires?
Most basic method. You will need 2 large flat screwdrivers or flat pry bars around 18 inches long. Lay the rim on a flat surface on the ground, Take the tire and spread a thin film of grease on the flat edge where it meets the rim when mounted. Set the tire on the rim and push one side over the rim as far as you can, probably just under half way around. It may be possible to screw the tire onto the rim. Think of the wheel as a bolt and the tire as a nut. Takes a little practice. If this didn't work, kneel on the side of the tire that is over the rim. Only the inside edge will go on. Where the tire meets the rim, move about 2 inches further around the rim and put one of the screwdrivers between the rim and tire with the handle across the center of the rim. Lift up on the screwdriver to force the tire over the rim. Repeat the process until the entire inside lip of the tire is over the wheel. You will need to hold the other edge of the tire in place where the tire meet the wheel. You may use both screwdrivers going back and forth till the tire mounts. Same process on the outside edge of the tire. Push as much of the tire as you can over the rim and push it down till it is in the center of the rim so you have some room to work the edge of the tire over the rim. It is impossible to get the tire mounted if it isn't in the low part of the rim. I hope this is clear enough, it is one of those things that is much easier to demostrate than it is to describe.
What size tires go on 96 s10 blazer?
Look in the tire wall it tells you the tire size "h&w" and rim size
