answersLogoWhite

0

The highest IP address among the active interfaces will be used.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

What network link would you use MT-RJ connectors?

A fiber optic connection between server and router


How can I install a home network for fiber optics?

To install a home network for fiber optics, you will need to first contact your internet service provider to ensure they offer fiber optic services to your area. Next, you will need to install a fiber optic modem and router in your home. Connect the fiber optic cable from the provider to the modem, and then connect the modem to the router. Finally, connect your devices to the router using Ethernet cables or Wi-Fi to access the high-speed fiber optic internet.


What kind of network uses SC connectors?

Fiber Optic connectors are normally either SC or ST SC is the accepted standard.(Network+ Guide to Networking answer)A fiber-optic connection between a server and router


Why do routers use anding?

ANDing is used by a router, to see if the host which has to be contacted, is on the local network of the router, or a remote network.


How can I connect fiber optic to wireless router?

You need to have a special converter or modem which is made for fiber optic networks. Usually such modems have a lan port for wireless routers or network switches.


Will including a router improve computer security?

A router can improve network security if it includes the use of NAT (network address translation) and/or a firewall.


How do you connect your PC and your PS3 to the internet at the same time?

Use a network router. Refer to user manuals and/or online guides on how to set up. Use a network router. Refer to user manuals and/or online guides on how to set up. Use a network router. Refer to user manuals and/or online guides on how to set up. Use a network router. Refer to user manuals and/or online guides on how to set up.


How do you configure RIP routing protocol on a Cisco router?

Here is a basic overview of the configuration of RIP on a Cisco router:Router(config)#router ripRouter(config-router)#network 192.168.1.0Router(config-router)#network 192.168.2.0Router(config-router)#network 192.168.3.0Router(config-router)#network 192.168.4.0Router(config-router)#network 192.168.5.0The 192.168.x.0 address can be changed to whatever address you would like to be broadcast over RIP. There are also other settings that can be configured.If you use RIPv2 you can also have the following configuration:Router(config)#router ripRouter(config-router)#version 2Router(config-router)#network 192.168.1.0Router(config-router)#network 192.168.2.0Router(config-router)#network 192.168.3.0Router(config-router)#network 192.168.4.0Router(config-router)#network 192.168.5.0Router(config-router)#exitRouter(config)#exitRouter#%SYS-5-CONFIG_I: Configured from console by consoleRouter#copy running-config startup-configDestination filename [startup-config]?Building configuration...[OK]Router#


What equipment use for connect from modem to your network?

Router will use connecting to modem


Which part a network layer address does the router use during path determination?

The network address


What do you call the router on a network that serves as an exit from that network?

stub router.


How do you connect two computers at different network on lan?

use a router !