Switch to a light source with a shorter wavelength....
Switch to a light source with a higher frequency
Increasing the intensity of light or using a shorter wavelength light source can cause an electric current to flow in a photoelectric effect experiment. The energy of the photons should be increased to overcome the work function of the metal surface, allowing electrons to be ejected and generate a current.
Switching to a brighter light source. Switch to a light source with a higher intensity.
brownout
This refers to the electric current in amps. There is no definition of what constitutes a low current, but in electronics it might refer to less than 1 mA, while in domestic power supply it might mean less than 5 amps.
Check that the wire that controls the seat adjustment has not been cut through.
1. Chemical bonding 2. Photo electric emission 3. Electric current flow 4. Radiation emission
Open the equipment, unsolder the connections to the transformer, remove the fastenings and remove it. Order a new on on ebay, when it arrives unpack it carefully, place it in the equipment, fasten it in, and resolder the connections. Simple! - (Historikeren 13-07-2014)
Not that familiar with Jeeps, but you could have a collapsed lifter, or you might have a rocker arm out of adjustment.
Yes, but we might not want to use it. The electric eel gets its electricity from its food, so it would me much easier to put solar panels on your roof and get energy from the sun then to get an electric eel and feed it so you can use its energy.
It cannot be done. A percentage is a pure number whereas a milliamp is a measure of electric current. A bank will charge some percentage interest on a loan. I am not sure how that might convert to a current!
if the dog goes near it and they might get shocked if it climbs on it. An electic dog fence will not cause damage to your dog. The voltage is rated low enough that it won't cause damage.
no adjustment for this car. it is hydraulic. if the clutch is not grabbing, it may be low on (brake) fluid, might have an air bubble in system, or might need the clutch, bearing and pressure plate to be replaced.