People have used a ballast for current regulation and you can use a breakdown diode for voltage regulation.
a. amperage and voltage b. the size and length of the wires c. voltage and resistance d. fuses and circuit breakers
The three electrical quantities are current voltage and resistance. Current is measured in amperes (A) and is the rate at which electricity flows through a conductor. Voltage is measured in volts (V) and is the electrical force pushing the current through the conductor. Resistance is measured in ohms () and is the opposition to the flow of current. Current - measured in amperes (A) Voltage - measured in volts (V) Resistance - measured in ohms ()
Electrical impedance is the total opposition to current flow. It includes both a resistive, or DC component and a reactive, or frequency-dependant component. Impedance is the same as resistance if the applied voltage is DC. For AC voltage, the reactive components opposition to current flow changes with frequency, so impedance is typically specified at a particular frequency.
Power Spikes
-- The voltage across every circuit element is the same, and is equal to the power supply voltage. -- The current through each circuit element is in inverse proportion to its impedance. -- The sum of the currents through all circuit elements is equal to the power supply current.
Electrical energy = (power) multiplied by (time) or (voltage across a component or circuit) times (current through it) times (time)
A resistor is a component of an electrical circuit that resists the flow of electrical current. A resistor has two terminals across which electricity must pass, and is designed to drop the voltage of the current as it flows from one terminal to the next. A resistor is primarily used to create and maintain a known safe current within an electrical component.
voltage = the electrical "pressure"current = the electrical "movement rate" or "flow rate"
Since voltage is electrical potential difference, to measure the voltage across a component, you place the voltmeter across, or in parallel with, the component.
current is the other factor. power (wattage) is the product of current (amps) and voltage
an amplifier is electronic equipment that increases strength of a signal and a booster is voltage regulation in (DC) direct current electrical power circuits. Basically an amplifier increases strength and a booster regulates voltage.
The commutator is the moving part of the electrical switch in motors that reverses the current direction between the rotor and the external circuit. This is applicable in electrical motors and electrical generators.
capacitors
A Generator is electrical machine which produces electrical current and voltage..
Theoretically there is no limit to the voltage of an electrical current.
A: A RESISTOR is a passive component it cannot control voltage these components and/or current it can however limit
A resistor is an electrical device that limits current in a circuit. It converts electrical energy into thermal energy (heat), and drops voltage. Conductors in an electrical circuit allow current to flow through them will little resistance. The medium in a resistor, the resistive material, is not a good conductor, and will "resist" the current that wants to flow through it. This is how it limits current in a circuit. A resistor is rated according to its resistance and it ability to dissipate heat. It will be rated in ohms of resistance and in watts. A one ohm resistor will allow one amp of current to flow through it when one volt is applied across it. It will generate one watt of thermal energy, which it will have to dissipate as heat.A resistor is an electrical component that limits or regulates the flow of electrical current in an electronic circuit. Resistors can also be used to provide a specific voltage for an active device such as a transistor.