0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is heatercore located on a 1999chevyprism?
where is heatercore located on a 1999 chevyprism
Where is the heatercore in a 1995 Chevy cavilier?
where is heatercore in a 1995 Chevy cavilier
How to get to the heatercore on A 92 Camaro?
you have to remove your steering wheel and dash completely out of the car then you can access the heatercore
Where is the ignition control module located on 1997 ford aerostar with a 3.0l engine?
in the engine compartment, passenger side fire wall by the heatercore hose connections. probably black, but could also be grey.
How do you replace the heatercore on 1998 E150?
Tits
How do you bypass the heatercore on a 1997 sunfire gt?
connect a piece of heater hose from the thermostate housing (where one of the hoses connected to from the heater core already is) to the connector for the coolant at the bottom of the enigine (where the second line should be connected).
Is there a hose going to the water pump on a 97 Pontiac grand prix?
There will be an input of some kind
How do you change a heatercore in a 2000 expedition?
You are going to want a service manual for this, because it involves removing a sizable portion of the dash board including the passenger airbag. You will likely need some (inexpensive) specialized tools to manage the hose connections as well.
1996 Pontiac sunfire elbow connected through the firewall is leaking antifreeze?
If its the little "elbow" that comes out of the fire wall on the engine side then it means the heatercore is leaking. This is a drain hose for the ac and if the heater core leaks it drains thru this tube
How do you purge a1985 Crown Victoria heatercore?
First, with engine off make sure the heater hose will come off easy. With engine at operating temp. and heater inside car on high, slowly open the heater hose to let out any air that is trapped. Yes, fluid will come out also. Do this a few times and check inside temp.
Is it possible to siphon gas?
Yes, as long as the exit point of the hose is lower than the input (suction) point. Once it is, you have to "bleed" the hose by sucking fuel through it; the gravity of the fuel falling out of the hose at the outlet will perpetuate the suction at the inlet.
How do you flush a heatercore in a Ford Taurus?
Disconnect both heater hoses from engine side, fabricate a fitting to attach a garden hose to one of the hoses coming from the heater, direct the other hose into a container, slowly turn on the water and flush until it runs clear, then reverse hoses and flush again until clear, reconnect hoses to engine and refill reservoir.
