0
Which id should not be used while assigning ids to SCSI peripherals?
Wiki User
∙ 13y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What allows you to attach peripherals such as disk drives and printers?
scsi port
Allows you to attach peripherals such as disk drives and printers?
scsi port
High speed parallel port to attach peripherals like disk drives and printers?
SCSI port Special high-speed parallel port to which peripherals, such as disk drives and printers, can be attached.
What is you replace a customer's hdd with a single ended scsi system using approximately eight meters of cables in the scsi system after this installation the peripherals have stopped functioning wh?
the cable length is too long.
When you install a SCSI drive should it be set to a master or to slave?
Master and slave does not apply to scsi drives
What is purpose of SCSI?
It connects eternal device, connects power supply to analyze data.-Small computer system interface.-for peripheral devices connectivity (8 devices (0-7))-Internal and external buses like power supply and extensive peripherals.-Ultra SCSI - 32 devices (no wire is required, all with is uses is wireless).-Physical drive accession - (Single hard dish is physical drive).-Logical drive accession.-SCSI ID is available in the device.Configuration done in booting.-5MB/Sec.-SCSI: 2--Fast SCSI - 10MB/Sec.--Wide SCSI - 16bit 20MB/Sec.-SCSI: 3--Support 32 device - 40MB/Sec.Note: the above answer is in the form of points.
How many devices can be daisy chained on a single standard SCSI controller?
Most modern SCSI buses support a total of 16 devices, while older SCSI implementations usually support only eight devices.
What is the purpose of SCSI?
It connects eternal device, connects power supply to analyze data.-Small computer system interface.-for peripheral devices connectivity (8 devices (0-7))-Internal and external buses like power supply and extensive peripherals.-Ultra SCSI - 32 devices (no wire is required, all with is uses is wireless).-Physical drive accession - (Single hard dish is physical drive).-Logical drive accession.-SCSI ID is available in the device.Configuration done in booting.-5MB/Sec.-SCSI: 2--Fast SCSI - 10MB/Sec.--Wide SCSI - 16bit 20MB/Sec.-SCSI: 3--Support 32 device - 40MB/Sec.Note: the above answer is in the form of points.
What scsi id should be assigned to a scsi-2 adapter card in a computer?
The host adapter is assigned SCSI ID 7, which has the highest priority over all other devices.
Which version of scsi is known as fast scsi?
SCSI-2
Which two SCSI connectors might be used with narrow SCSI?
DB25 SCSI connector50 pin SCSI connector
Which SCSI is known as fast SCSI and has a 68 pin connector?
SCSI 3
