answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Which is a to make a steel rod into a magnet?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you make a magnet by banging and hitting?

By striking the side of the end of a steel rod with a hammer you will make a weak magnet.


How do you make an iron rod into a magnet?

Same direction!


Will rod magnet still become a magnet when it cut across into thin slices?

yes.when you slice a rod magnet it will still be considered as a magnet


Do steel wire screen sticks to magnet?

Steel will stick to magnets, but stainless steel will not.


What magnet does a magnetic strip use?

To remain a magnet it has to be made out of steel as steel makes a permanent magnet.


Can steel can attract with south pole magnet?

Either pole of a magnet can attract steel.


How do you tell what are aluminum wheels?

If the wheels are steel, a magnet will stick. If aluminum, it will not.If the wheels are steel, a magnet will stick. If aluminum, it will not.


When you touch a magnet to a steel nail the nail attracts steel paper clips. Explaine why this does not happen when you use an aluminum nail?

it wouldn't be magnet to a aluminum nail because the aluminum is not a way of magnet and a steel nail would because steel is a way of magnet.


Does steel attract a scrap heap magnet?

A scrap heap magnet attracts steel - but not steel with a high chromium or nickel content


What are the materials used to make a javelin?

to make a javelin you need a fiberglass rod and a steel tip


Would increasing the length of a rod in an electromagnet increase it's magnetism?

No, as in this case,the rod is the magnet,and the strength of a magnet does not depend on its size.


How can you determine the magnet if you have one brass rod and another magnet in space?

Cut one in half, and see if the two bits attract or repel one another. If they do, you have cut the magnet. Otherwise the rod. If you are allowed other equipment, you don't need to cut anything. Make a coil, connect to a meter, and see which rod, when pushed in and out of the coil, induces a current.