You can't really separate them. It's the current flowing through your body that does the damage, but the value of the current depends on the voltage across your body -the higher the voltage, the higher the resulting current.
whenever u tough the current flowing through wire get shocked or gets dead is said to be dangerous current.
no actually dc current is more dangerous than ac because dc is a direct current and has no current zero condition ,which is very dangerous and do not leave us if we get shock while ac current leave us when we get shock
it is a flow of charge practically from negative to positive terminal
It is difficult to define the value which may cause death. I think it the voltage which is dangerous. Approximately a voltage of 50V is dangerous for heart.
Current is measured in amps so the setting on a multimeter would be A Measuring current with a multimeter is only to be done by someone with training because it can be very dangerous It is much better to measure current with a clamp meter
Yes. Water can damage the breaker and prevent it from working, or it may continue to carry current after the breaker trips.
Current causes muscles to contract and that is dangerous especially if the heart muscle is affected.
Current is what is can hurt or kill you.
? rip current ?
no actually dc current is more dangerous than ac because dc is a direct current and has no current zero condition ,which is very dangerous and do not leave us if we get shock while ac current leave us when we get shock
NO....
either one, neither one
How high is the voltage that is being used? With high enough voltage any current is dangerous.
quite fast and very strong and dangerous
The coast of Newfoundland is dangerous for navigation because it is an island present in the north Atlantic between the gulf of st. Lawrence and the Labrador current the labrador current beings in a great deal of ice, rocks, mist and wind which makes it dangerous for navigation
it is a flow of charge practically from negative to positive terminal
Another name for a circuit with low resistance and high current is a short circuit. It is dangerous because, if you have sufficient energy in the power source, you can damage components and/or cause fires.
It's a decision based on efficiency of power transmission.