0
Which lubricant should be used when connecting the parts of an oxy fuel gas welder?
Wiki User
∙ 11y ago
No petroleum based lubricants of any kind should be used on oxygen acetylene equipment. Using them can cause unexpected flash fires even if the equipment is not ready for use. If you need to lubricate threads on gauges or torch connections, use liquid soap.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What is welder fabricator?
A Welder Fabricator is some one that welds as well as assemble parts to make machinery.
What machine parts are used to reduce friction?
I think it would a lubricant not a part...
What is the purpose of oil within a refrigeration system?
It's a Lubricant. It lubricates parts.
What does the welder do?
Generally the title of 'fitter' is applied to the person who does the layout, preparation and positioning of parts to be welded. They may also do the cutting of the parts to be assembled and the tacking the parts in place. A 'welder' then comes behind the fitter and welds the parts together. A 'fitter and welder' does the entire job and all the aspects of it.
What OF parts of circuit?
Simple parts of a circuit are switches, light bulb, battery and connecting wires.
In mechanics what is a device for connecting parts of machinery?
knuckle joint
Will your car overheat if you need oil?
Depends on how much oil there is. Running any four-stroke engine with low or no oil is going to cause serious damage. Connecting rods and head parts would most likely go first. Oil acts as a coolant for internal parts as well as a lubricant. Without oil to lubricate, parts will only get hotter, and without oil to cool them, bad, bad things will happen.
How do you speed up the power window on a 1997 Toyota Camry?
You have to put some lubricant on all sliding parts (power window mechanism). You might need to put a little bit of lubricant in between glass and rubber parts too. Also you might have to clean certain parts of the mechanism if it was contaminated before.
What is an FP10?
FP-10 is a lubricant used in guns that helps to reduce the friction between moving parts.
How do you reduce friction in machines in factories?
You would put a lubricant - oil or grease - between the moving parts.
What if there were no bridge connecting the two parts of Michigan?
you would have to drive a long time!
What is coastal corridor?
A corridor is a gallery or passage connecting parts of a building; hallway.
