Want this question answered?
Definitely not. The insulation is the wrong type. Under ground wire insulation is much thicker and is made of a material that is impervious to water infiltration.
By "clear insulation," I assume you mean the type of wire used in some lamp cords. If so, the hot wire is the one with the smooth (non-ribbed) insulation.
The insulation will be green in colour. Also bare copper can be used as a ground wire.
Not that I know of. When insulation is applied to wire it is extruded so that the insulating material is uniform around the conductor. Without this uniformity the conductors insulation factor would vary and the wire would have to be rated at the lowest reading factor when tested with a high voltage. Even when splicing a wire, the electrical code states that the insulation covering the splice has to be brought up to or surpass the insulation factor that is supplied by the manufacturer of the wire.
Magnetic wire has a coating of varnish for an insulation.
Definitely not. The insulation is the wrong type. Under ground wire insulation is much thicker and is made of a material that is impervious to water infiltration.
Electrical insulation on a wire or cable composed of plastic. Most wires and cables use plastic insulation. Some other types of insulation used on wires and cables are: enamel, cloth, natural rubber, gutta percha, ceramic, etc.
The wiring material that should be used is lamp cord. You don't have to coat the wire as it has insulation already applied to the wire by the manufacturer.
most likely the rubber or plastic wiring insulation.
By "clear insulation," I assume you mean the type of wire used in some lamp cords. If so, the hot wire is the one with the smooth (non-ribbed) insulation.
The insulation will be green in colour. Also bare copper can be used as a ground wire.
Magnesium oxide is used in heating elements to isolate the inside heating wire from the elements outside sheath. This same material is used in Pyrotenax mineral insulated cables as an insulation medium.
Not that I know of. When insulation is applied to wire it is extruded so that the insulating material is uniform around the conductor. Without this uniformity the conductors insulation factor would vary and the wire would have to be rated at the lowest reading factor when tested with a high voltage. Even when splicing a wire, the electrical code states that the insulation covering the splice has to be brought up to or surpass the insulation factor that is supplied by the manufacturer of the wire.
Porcelain
Cross link polyvinyl chloride RW90 (PVC) and THHN are two common types of insulation THHN wire stands for thermoplastic high heat resistant nylon coated wire. THWN stands for thermoplastic heat- and moisture resistant nylon coated wire.
Magnetic wire has a coating of varnish for an insulation.
Usually heat insulation plate is used