Anything over a gigabyte would be ideal for that processor speed.
Double Data Rate (DDR) memory gets its name from the fact that it uses both the rising and falling edges of the clock cycle, thus allowing it to double its performance in a given clock cycle.
For DDR(CAS / DATA RATE) * 2000 = X ns(7/1333MHz) *2000 = 10.5 ns
The specifications are memory chips and memory modules. The DDR PC3200 RAM is a popular choice when one has to specify in this specific memory equipment.
Data Generating Capability of a Device is called Clock Rate. If the clock rate is high, the processing will be slow down. If the clock rate is low, the processing will be high.
DDR stands for Double Data Rate, which means data travels at twice the clock rate. DDR is referring to RAM or Random Access Memory and the connector is the socket into which you install RAM.
SD DDR2 Ram is a double data rate synchronous dynamic random access memory interface. In addition to double pumping the data bus as in DDR SDRAM, (transferring data on the rising and falling edges of the bus clock signal), DDR2 employs an I/O buffer between the memory and the data bus so that the data bus can be run at twice the speed of the memory clock. The two factors combine to achieve a total of 4 data transfers per memory clock cycle.
The speed of a computer is one of its strengths. However, the clock speed of the processor chip is not a direct indicator of a particular computer's strength in comparison to others. For instance, a computer might have a lower clock rate in MHz but have more efficient instructions, enabling it to outperform a faster computer. The machine with the slower clock rate might also use faster memory as well.
The best type of GDDR (Graphics double data rate) or graphical memory is GDDR5.
Stands for "Double Data Rate." It is an advanced version of SDRAM, a type of computer memory. DDR-SDRAM, sometimes called "SDRAM II," can transfer data twice as fast as regular SDRAM chips. This is because DDR memory can send and receive signals twice per clock cycle. The efficient operation of DDR-SDRAM makes the memory great for notebook computers since it uses up less power.
To configure the clock rate for the hardware connections on serial interfaces such as network interface modules (NIMs) and interface processors to an acceptable bit rate, use the clock rate interface configuration command. Use the no form of this command to remove the clock rate if you change the interface from a DCE to a DTE device. Using the no form of this command on a DCE interface sets the clock rate to the hardware-dependent default value.
A clock-rate is the speed at which the Serial connection sends data to another router and each connection must match the others clock-speed or a speed mismatch error will occur. For packet tracer, the clock-rate has no effect.
It is 100000 Hertz.