Want this question answered?
are a measure of angular velocity whereas metres per minute are a measure of linear velocity.
You cannot. Revolutions per minute are a measure of angular velocity whereas metres per minute are a measure of linear velocity. There is no simple way to convert from one to the other. For example, at any given rpm, a point on the rim of a wheel is moving much faster than a point near the hub. You need the distance of a point from the axis of revolution (in metres) to convert angular speed to linear speed. If the distance from the centre is r metres then the point moves through 2*pi*r metres every revolution. ie 1 rpm = 2*pi*r linear metres per minute.
RPM is an expression of rotational velocity. It is the number of revolutions a rotating object makes on its own axis in one minute. RPM is used to calculate horsepower, linear velocity, gear ratios, and tangential velocity. The formula for roller rpm = Distance / Circumference.
After any whole number of revolutions, the total displacement is zeroand so the average velocity is zero.At any instant, the magnitude (speed component) of instantaneous velocity is(pi) x (distance from center of rotation) x (RPM / 30) units per second.
Two pie over 60 Radian per Minute.
The velocity of the nozzle in a cylinder can be calculated by dividing the displacement by the amount of time. For example, if 1 cubic foot of gas is released over 1 minute, it would have a velocity of 1 foot per minute.
Second minute: the si base unit for time is secondvelocity: the si base unit for velocity is meters / second (m/s)
Short for cubic feet per minute, a measurement of the velocity at which air flows into or out of a space.
You need to know the area of the pipe or duct. If you have that area, in square feet, V = Q/A where V = velocity (ft/minute in this case), Q = flowrate (cubic feet/minute in ths case), and A = area (square feet in this case). Then, you just have to apply conversions to get whatever units you want to present or use the answer in.
The linear (tangential) speed of a point on a spinning circle is(angular speed of the spin) x (radius of the circle). Note that this only works if the angular speed is in units of radians/time .To convert degrees to radians, multiply by (pi)/180 ... about 0.01745 .
velocity=distancextime distance=220cm time=5.7 mins velocity=220 x 5.7 ______ 1100 1540 ______ 1254.0 ______ velocity=1254cm/minute
The distance depends on how far the relevant point on the minute hand is from its point of rotation. This is because the motion of the minute hand is angular, not linear.