Bank 2 - passenger side. Sensor 1 - before the catalytic converter.
Dodge doesn't use fuel pressure sensors on any of it's engines.
The 4.7L 2002 dodge durango has 4 O2 sensors. ref. Chilton's Dodge Durango/Dakota 2001-03 repair manual. page 6-19 (Oxygen sensor - general info and replacement) The upstream oxygen sensor is located before the catalytic converter. The downstream oxygen sensor is located is located after the catalytic converter.
On top of the rear axle. This is from pictures I've seen from guy that replaced their own sensors.
The oxygen sensor is located in the exhaust system on a 2005 Dodge Durango Hemi 5.7. There is a sensor located before and after the catalytic converter.
The PCM uses a dozen sensors that are located all over the engine.The PCM uses a dozen sensors that are located all over the engine.
The 2006 Dodge Durango camshaft position sensor is located on the back end of the head. The position sensor should be labeled as such.
On either side of the catalyitc converters.
Where is a camshaft position senser located on a 2006 Dodge durango/
The vehicle speed sensor is located on the top center of the rear axle.
Where is a camshaft position senser located on a 2006 dodge durango/
In the rear of the drum
If it is saying that the heater circuit has failed then this O2 sensor has failed. The o2 sensors have tip heaters in them. These are irreplaceable. Replace the whole sensor. This particular sensor is located on the driver's side exhaust in front of the Catalytic Convertor.