0
Which of the following tools could you use to determine whether a user's workstation is transmitting packets in the proper Ethernet frame type for your network?
Wiki User
∙ 12y ago
a. Multimeter
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Why is it advisable to enter a next-hop IP address when creating a static route whose exit interface is an Ethernet network?
In a multi-access network, the router cannot determine the next-hop MAC address for the Ethernet frame without a next-hop address.
Which of the two following might cause excessive data collisions on a ethernet network?
Excessive broadcasts, and using hubs instead of switches or routers to segment the network.
What is another name for an Ethernet cable?
another name for an ethernet cable is a cat5 or cat5e cable
What are the Ethernet frame parts?
what are the ethernet frame parts The source and destination MAC addresses
How can you get two separate ethernet plug-ins to 1 router if you only jave 2 ethernet plug-in?
If you don't have enough ethernet sockets in a router, you can plug a switch or a hub into the socket. The hub or switch will supply support for additional ethernet cables.
Which tool can you use to determine whether a workstation is transmitting packets in proper Ethernet frame type for your network?
You need a protocol analyzer or a packet sniffer. They will capture packets and attempt to analyze them for proper protocol.
What is giga ethernet?
Giga ethernet is technologies for transmitting Ethernetframes at a rate of a gigabit per second,
Is the IEEE standard for fiber optic Ethernet networks transmitting data at 10 Gbps?
The standard for fiber-optic Ethernet transmittion is 802.3ae
Is the IEEE standard for fiber-optic Ethernet networks transmitting data at 10 Gbps?
The standard for fiber-optic Ethernet transmittion is 802.3ae
Nodes transmitting after detecting that no other transmissions are taking place?
Ethernet, makes sure there is no traffic.
When two nodes using Ethernet protocol access a LAN and begin transmitting data simultaneously it is known as a what?
a collision
What is 10BaseT Ethernet NIC?
It is a Network Interface Card that connects 10BaseT Networks together A 10BaseT Cable is an Ethernet Cable consisting of 4 pairs of wires 2 for transmitting and 2 for receiving
Which of the following is credited with inventing ethernet?
Robert Metcalfe
How do you wire a network?
Ethernet is the standard now, so Cat5e or better cabling is the way to go. All workstation/phone endpoints should be wired back to a central closet that will contain the Ethernet switch. Maximum cable distance is 300 feet.
What is the command to determine if interface Ethernet 0 is active?
Run "ipconfig".. If your Ethernet will be active it will show you the current IP address of NIC..
What is the thing that happens when a collision occurs in an Ethernet network?
When a collision occurs, the stations back off and stop transmitting. After a randomly chosen period of delay, the data is resent.
Which two of the following are disadvantages to using token ring networks rather than Ethernet networks?
They are more expensive and are slower than Ethernet.
