what are the ethernet frame parts The source and destination MAC addresses
Frame Size
ethernet frame required minimum of 64 bytes expalin why?
The minimum size of an Ethernet frame is 64 bytes. Even if the VLAN tag is 4 bytes, the Ethernet frame with VLAN tagging remains 64 bytes.
seven
Each Ethernet frame contains a trailer with a cyclic redundancy check (CRC) of the frame contents. After reception of a frame, the receiving node creates a CRC from the bits in the frame to compare to the CRC value in the frame trailer. If these two CRC calculations match, the frame can be trusted as being received without error. The trusted frame will then be processed. A frame received with bad, nonmatching CRC's will be discarded.
Which parts of an Ethernet frame are Wireshark and other protocols analyzers unlikely to capture
IP, Ethernet, Frame Relay, ...IP, Ethernet, Frame Relay, ...IP, Ethernet, Frame Relay, ...IP, Ethernet, Frame Relay, ...
Arpa encapsulation must be used to enable Ethernet II frame type on your Ethernet.
type
type
type
Type
Frame Size
ethernet frame required minimum of 64 bytes expalin why?
Ethernet II
The information found in the Ethernet frame trailer would be the error checking code.
No, not all Ethernet frame sizes are the same. The standard Ethernet frame size ranges from a minimum of 64 bytes to a maximum of 1518 bytes for standard Ethernet. However, with the introduction of Jumbo Frames, the maximum size can be increased to 9000 bytes or more, depending on network configurations. Different Ethernet standards and network requirements may dictate specific frame sizes.