i thik a chine is conect in between them.
A Crank Shaft Position Sensor is a magnetic sensor that determines the position of the engine's crankshaft. It is used to set the electronic timing for the car's computer, so it is a very important part of the electronics.
No
It is the part inside the lower portion of the engine that the center bottom pulley attaches to.
crank is nothing but disk and it is a rotating part and it is couple with crank shaft
Inside the lower part of the engine. The pistons are connected to the crankshaft by way of rods. Here is a rough diagram.
Where is the crank shaft located on a 1999 Pontiac Bonneville? I have bought the part. Just can't find where it goes.
You cannot see the crankshaft without dissembling the engine. It is located inside the engine, lower part of the engine block. Pistons and connecting rods are bolted to the crankshaft.
The 95 model doesn't have one externally. It's called an optical pickup and is part of the distributor. It can't be purchased separately.
The crank sensor is an important part of the engine wiring. Without it the engine does not know when to fire. There is no way to by pass it.
Yes, this is true for the 2.5 engine. The part # has been updated a number of times by Nissan and both cam and crank sensors are now the same part#.
what is the cost of head light doom of a hero Honda splendor bike in India.
Honda Crank Pulley Tool 50mm. The part number is 646796 at DenLorsTools.com. There is a video that shows it in use.