Want this question answered?
The shoulder pulley is actually an exercise device, so it isn't appropriate for your use. You need a wench system, available from industrial supply houses.
A fixed pulley is a pulley that is attached to a support. It does not reduce the effort needed to lift the load, but rather changes the direction of the applied force.An example of a fixed pulley would be the rope pulley on a well. This is a fixed pulley because the pulley doesn't move (it is attached to the overhead structure).
Shoulder pulleys are similar to suspension trainers in that they both use tension in order to produce a workout. The main difference is that suspension trainers are usually attached to a surface while shoulder pulleys are not.
No, a pulley will not keep a car from starting. A pulley is part of a wheel, and it is held on by an axle. There are many other components that go into this, but none of them have to do with the engine working.
A shoulder bolt is a bolt which has an non-threaded shaft at the top, immediately below the bolt head. This means the bolt can turn when in place, which is useful in applications such as in a pulley.
There are two Pulleys to the left of the alternator that have caps. Look at the pulley farthest from the alternator. If you look below this pulley, you will see (or feel) two bolt shaped structures. One is a bolt, the other is not a bolt. Attach a rachet to this bolt shape structure (not the bolt) and as you put pressure on this structure, the pulley will move.
With that type of injury, I don't think that would be a good idea. Be sure you consult your doctor before you start any exercise, especially with such a serious existing injury.
The tension pulley or any one of the other pulleys is not square to the motor. Possibly the bearing in the pulley is going and allowing the pulley to tilt. The tension pulley does wear out usually quicker than one of the components the belt drives.
Lifting pulleys are attached to an overhead structure, and change the direction of force. You pull down, and the pulley pulls up.
It depends on which pulley. Locate the problem one and replace it. It may be the water pump or alternater in which case those components need replacement. Also may be the idler pulley is bad.
V-belt pulleys are essential mechanical components that have been used for decades to transmit power in various industries.
To make a 3rd-grade pulley project, you will need a pulley system, string or rope, and a load to lift. Start by attaching the pulley to a stable structure. Then, thread the string or rope through the groove of the pulley and attach it to the load. To demonstrate how pulleys work, have the child pull the loose end of the string to lift the load using the pulley system. You can also experiment with different pulley configurations to explore mechanical advantage.