answersLogoWhite

0


Best Answer

I would say Duct Tape.

Duct tape has considerably stronger adhesive than electric tape. On the other hand, electric tape will stretch when put in tension when duct tape may just tear - so it depends on the type of strength you are looking for.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Which tape is stronger electric tape or duct tape?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Continue Learning about Electrical Engineering

Can you replace electrical tape with duct tape to cover an exposed wire?

NO it is dangerous.


Does duct tape conduct electricity?

Yes. It should not be used where there is any danger to electrical leakage. Definitely not on 110/220 VAC lines.


Can duct tape be used on electrical projects?

it can be used but i would not recommend it. I would recommend going out to lowes or home depot and getting electrical tape. It is better for electrical projects and it can cost less than duct tape.Electrical Tape provides stretching and waterproofing qualities, electrical tape is non-conductive and is used to cover and insulate electrical splices and for other electrical uses.Duct Tape should be used for its original purpose only - temporary, emergency repairs.Please do not take chances especially when dealing with electricity. Duct tape is not designed for electrical work. Stay safe and use the appropriate tools and materials for the job. In addition, if you are doing this yourself and the job is electrical home wiring (outlets, etc.), I would recommend you do not. In most states this requires a licensed electrician. Please to not put yourself and/or family in jeopardy, its just not worth it.


How will you make an electromagnet stronger without changing the electric cell fitted to the circuit?

Adding more turns of wire to the electromagnet will make it stronger without changing the applied voltage.


What is disadvantage to lay power cable in the duct?

If you lay a power cable in a duct, and it overheats due to a short or overload, the smoke from the cable burning will fill the duct and be transported by the duct to places it should not be. If the cable is not balanced, i.e. not paired up with its neutral return, current in the cable will induce a current in the duct via electromagnetic induction, causing heat, loss of power, and potentially fire, even if the original circuit was operating normally. The latter effect is why penetrations for single cables in distribution panels must be slotted, so as to break the electromagnetic field.