Are USB and PS/2
Are USB and PS/2
An RJ11 connector is a six-position two-conductor connector. An RJ9 connector is a term for a four-position, four-conductor connector that is often used to connect a handset to the base of a telephone.
As a noun, a peripheral means a piece of equipment that is connected to a computer but is not an essential part of it. An example of this would be a printer or a speaker.
1) connect the ip phone to the ethernet LAN using an rj45 connector 2) establish an internet connection then use an analog telephone adapter.
Crimping tools are designed to connect a connector to a cable. It is used on phone cables as well as network cables. All you do is place the connector with wires into the tool and squeeze the handle.
The two wires which connect the timer switch on a Century 87423 battery charger are the red and black wires. The red goes to the positive connector while the black goes to the negative connector.
Typically, CD-ROMs are connected using a power connector called a Molex Connector. A Molex Connector has four wires, two for power, the other two for grounding. This connector supplies two different voltages to the device it is connected to - 12v and 5v. For more information on Molex Connectors, see the article here: http://en.wikipedia.org/wiki/Molex_connector#Disk_drive_connector_.28AMP_Commercial_MATE-N-LOK.29
There are two cables that connect to the floppy drive in a desktop computer.There is a four pin power cableThere is a ribbon cable that has a part twisted end (the twisted end connects to the floppy drive).
To connect two soaker hoses together, you can use a hose connector or a hose mender. Simply cut the ends of the hoses evenly, insert the connector or mender, and tighten the clamps to secure the connection. This will allow water to flow seamlessly between the two hoses for efficient watering.
The BNC is a crimp-type connector. It is designed to be used with RG6 cable or similar, but may work with your other cables. The connector has to mated to the diameter of the wire used. If the wire is too thin or there isn't many conductor strands in the cable, using this type of connector is risky. If you just want to connect these two different types, there are many BNC to RCA adapters available.
• Routing group connectorThe routing group connector is the recommended connector for connecting routing groups that are in the same Exchange organization. This connector uses SMTP to transfer messages to other servers running Exchange Server 2003. The routing group connector can only be used to connect routing groups.• SMTP connectorThe SMTP connector establishes a messaging route between two routing groups or between a routing group and a non-Exchange SMTP host. Although the routing group connector and the SMTP connector use SMTP as the transport protocol, the SMTP connector provides additional functionality in that it can be used to connect an Exchange organization with any SMTP server.• X.400 connectorThe X.400 connector establishes an X.400 messaging route between two routing groups or between a routing group and an X.400 system. Like the routing group connector and the SMTP connector, an X.400 connector can be used to link Exchange routing groups. Generally, X.400 connectors are used only when connecting to other X.400 messaging systems.Exchange Server 2003 supports the following optional connectors that you can use to connect the organization to non-Exchange messaging systems:• Exchange Calendar ConnectorExchange Calendar Connector is used for exchanging free/busy information between an Exchange organization and a Lotus Notes or Novell GroupWise messaging system.• Exchange Connector for Lotus Notes• Exchange Connector for Novell GroupWise
Outlook Connector is an add-on for the Outlook mail application that lets users connect their hotmail account to their Outlook program, allowing them to control their hotmail from Outlook.