Flash Memory
TFTP server
TFTP server, Flash
banner motd
the router is assigned an ip address.
loading Cisco IOS software
No router eigrp <AS #> No router ospf <process ID> No router bgp <AS #> No router rip
A router does not have RAM. A router distributes data. The router does not hold data nor does it process data.
during a file transfer operation during a normal boot process when the full IOS cannot be found when the running configuration directs the router to do this
*router is a device use to route communication or connection *routing is the process *router is a device use to route communication or connection *routing is the process
A 802.11 Service set Identifier is not installed, it is automatically assigned during the manufacturing process and is broadcasted when a Modem/Router is initialized as the Wireless Access Point. The SSID can be changed in the modem/router settings.
no router rip
No, You cannot run two BGP process on a Single Router. Yes, it is possible if you use different VRFs
Page 11 of Routing Protocols and Concepts by Cisco. 1. POST 2. Loads Bootstrap program 3. Locates Cisco IOS 4. Loads Cisco IOS 5. Locates the configuration file 6. Load the startup configuration file or enters setup mode