Spring towards engine.
Go to link below.
i set my thermostat to cool, my heat pump start it go to heat but not cool, i think the thermostat. can u help.
the thermostat can be used to measure the temperature in a room. when.... (to see more please go to my website to see more).
There are two ways to do this. Fist is there is a small nut located behind the heater coil on the thermostat. It takes a special wrench to turn this nut. You can get them where you buy your thermostat. The second way is to back off the screws that hold the backer plate to the wall and check it for level. Once it is level tighten the screws and connect the thermostat back to the backer plate.
Just won't properly work car will most likely overheat
The way it came out....
yes one way
ok
Down
Spring down.
Normally spring down.
It goes up.
The spring side of any thermostat always goes towards the engine.
The spring goes into the engine.
spring down
The side of the thermostat that has a spring showing faces into the engine.
The side with the spring faces into the engine.