Right or clockwise to tighten it. Left or counter clock wise to loosen it. Righty tighty Lefty loosey.
Unscrew the ball from the rod counter clockwise until it is off.
Turn the water off to the faucet. Remove the handle. The top of the faucet should unscrew to get to the ball valve. Replace the valve and gaskets then reassemble the faucet.
when the dsi freezes you have to unscrew the battery out and unplug the charger the dsi should turn completely off wait about ten seconds and screw the battery back in.
Generally you unscrew the top ball (the one on the top, outside of your belly button rather than on the under, inside), but sometimes if the ball is on there really tight you'll need to use pliers to unscrew it. Just be careful and make sure you don't lose the ball, but if you do you can always use a ball from another ring.
you have to get 1 master ball then save it next turn the DS off and turn it back on then you should have 999 balls which will never go down unless you toss them!
Simply unscrew the ball off of either side of the barbell and remove the jewellery.
A ball valve is used to turn water , gas or oil on and off.
you turn off the switch by climbing the chains and dodge the spike ball and go to the middle and turn the switch
First, turn the smallest box into a ball so it will land underneath the wood thing. Then, turn the red box into a ball. Lastly, turn the biggest box into a ball and it will knock the red ball off.
Unscrew the ball or gem. If it's too tight to unscrew, either go to your piercer for a longer bar, or soak it in warm water to relieve the swelling.
You turn off the main valve and drain water, unscrew old tank and fit new one. Turn on water again.
Thw best thing to do is to tighten the ball on the barbell with a pair of pliers, the ball won't unscrew unless you loosen the ball again using pliers.