0
vertically
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you install a water hammer?
No one ever installs a water hammer they install a shock absorber such as an air chamber
How can you stop water pipes from water hammer?
Install a water hammer arrestor (air chamber)
Will a expansion tank help prevent water hammer?
no, you need a hammer arrestor.
Should the cold-water inlet and hot-water outlet be the same size on a 50-gallon electric water heater?
The inlet and outlets are the same size on a tank, weather your plumbing is the same size should be the question. This is not critical, but they should be the same,if there is no backflow restrictor on a plubic line and the inlet is larger then the outlet,then you could be pushing hot water into the pubic line. New installs recommend an expansion tank,but few people install them,unless they get water hammer,knocking sounds. But most new water heaters have a restrictor built into the inlet. There is no difference between gas and electric, the water does not know how it is being heated.
Cost to install a hot water heater?
30gal.hot water tank cost+installation
Who invented water hammer arresters?
John Watts
How do you install a water hammer?
No one ever installs a water hammer they install a shock absorber such as an air chamber
How can you stop water pipes from water hammer?
Install a water hammer arrestor (air chamber)
What is the wrong when pipe make sound as you turn on the water?
Most likely your water pressure is too high, and the water flow is causing water hammer on your pipes at the turns. To alleviate this, you can lower your water pressure, or install shock arresters at the problematic areas. Or, it's possible that your pipes are rubbing against metal hangers, causing the noise. You can put tape on the pipe at the hangers. == Answer== If it were water hammer, I think it would make the sound when you turned the water off not on. I would go for a loose washer on faucet. If that is what you mean by turning on water.
How do you stop hammer in water pipes?
install an air hammer arrester. Any plumber can install it in a few minutes. Also make sure your water pressure isn't to high
Why even after putting water hammer arresters pipes are rattling on opening and closing of taps?
First follow all water lines to make sure there secure, and if they are you should Install an expansion tank, they are sized by gallon, per water pressure and hot water tank size, pressure relief,heater temp. Check your water pressure and make sure your expansion tank is charged to the same pressure after you buy one. If you go to watts.com there is a nice calc for ex tank size. There is probably a check valve before or just after you water meter which does not allow for the expansion of the hot water heater and also you could have just over 40psi coming from your water authority, in which case those small arresters are not enough.
How do you stop the pipes from rattling when turning on hot water in bathroom tub?
Install anti-hammer arrestor in hot water line at tub. It should help.
How do you remove air from water lines?
Install hammer arrestors at the highest point of the water lines.
Where do you find water hammer?
you can find water hammer In plumbing that is not fastened properly. Water hammer is not an "It" Its the sound made when water is turned off suddenly and the loosely fastened pipes make a banging sound.
Water hammer presure if valve is suddenly closed?
You need to install a Water Hammer Arrestor. You can purchase types that attach to the supply connection of the fixture that is having the problem. Usually these can be installed by inexperienced home owners. Check your local Home Improvement Store or Hardware store. Also the sales associate should be able to show you how to install them.
What causes hard knocking in the water line?
Water hammer is caused by inadequate strapping or restraining of water lines or excessive pressure. Install a water hammer arrestor at the fixture and strap the lines more securely.
How do you prevent taps from knocking?
If possible, install hammer arrestors in hot and cold water mains.
