John Watts
vertically
to hammer stuff
Most likely your water pressure is too high, and the water flow is causing water hammer on your pipes at the turns. To alleviate this, you can lower your water pressure, or install shock arresters at the problematic areas. Or, it's possible that your pipes are rubbing against metal hangers, causing the noise. You can put tape on the pipe at the hangers. == Answer== If it were water hammer, I think it would make the sound when you turned the water off not on. I would go for a loose washer on faucet. If that is what you mean by turning on water.
The War Hammer fantasy was invented in 1982. War Hammer 40k in 1987. Hope this helps !
The steam hammer was invented around 1837 by the Scot James Nasmyth.
It is believed that the sledge hammer was invented about 30,000 BC during the middle of the Paleolithic Stone Age.
First follow all water lines to make sure there secure, and if they are you should Install an expansion tank, they are sized by gallon, per water pressure and hot water tank size, pressure relief,heater temp. Check your water pressure and make sure your expansion tank is charged to the same pressure after you buy one. If you go to watts.com there is a nice calc for ex tank size. There is probably a check valve before or just after you water meter which does not allow for the expansion of the hot water heater and also you could have just over 40psi coming from your water authority, in which case those small arresters are not enough.
Your mom is what year they were invented
No. Installing an anti-hammer arrestor in water line will take care of water hammer.
Thor's Hammer
Around 1880.
There is no named inventor for hammer.