by:rougebankgirl
Anaphase is the phase when the individual chromosomes move apart to opposite ends of the cell.
A settlement ends during the trial phase and a dismissal with prejudice ends after the trial.
The second phase of the menstrual cycle is called the luteal phase. It begins after ovulation and ends just before the start of the next period. During this phase, the uterine lining thickens in preparation for a possible pregnancy.
The phase of mitosis that ends when the chromosomes stop moving is called metaphase. In metaphase, the chromosomes align along the cell's equator, and the spindle fibers attach to the centromeres of each chromosome. Once the chromosomes are properly aligned, the cell can proceed to the next phase of mitosis.
A fillet weld in any single continuous weldmay underrun the nominal fillet weld size specified by2 mm [1/16 in] without correction, provided that theundersize portion of the weld does not exceed 10% of thelength of the weld. On the web-to-flange welds on girders,underrun shall be prohibited at the ends for a lengthequal to twice the width of the flange.
A buttweld is a junction welded by heating two ends of metal with a weld plate and joining them under a specific pressure.
It is the only type of weld you can make to seal this type of joint. There are flange ends that can be welded onto pipe with a butt weld, but sockets and slip-ons must be fillet welded.
Through successive rounds of mitosis, replication of DNA in the S-phase of interphase results in shorter and shorter chromosomes. The structures called telomeres are attached to the ends of the chromosomes to prevent the chromosomes from becoming too short.
called prophase. During prophase, the nuclear membrane breaks down and the chromatin condenses into visible chromosomes. The centrosomes begin to move to opposite ends of the cell, and spindle fibers start to form.
The ends of an island are typically called "tips" or "points."
starts with a c ends with a d
To join ABS pipes using solvent weld, you need to first clean and dry the pipe ends. Then, apply ABS cement to both the pipe ends and the fitting, and quickly push them together. Hold the joint in place for a few seconds to allow the cement to set. This creates a strong, permanent bond between the pipes.