Want this question answered?
Sounds like starter solenoid needs to be replaced
no no! No! NO! He didn't!
scew u all
installing a Chrysler mirrorFirst of all you would have to take of the door panel, there are about 6 0r 7 screws the first one is located behind the door handle and there is a cap in which you have to pop out with a scew driver and the other one is on the door handle ,down where you use your hand to close the door. Again you have to pop out the cap with a scew driver to get to the screw. then you will find about 4 scews around the speakers and take them out At the top of the door where the panel is there are about 3 10mm bolts
scew off
You need to remove the arm rest, and the power lock switche,and the mirror control. pop all the panel clips on the edge of the door panel with a scew driver. Than with the window down, lift up on the panel .
take out the scew on the bottom side of the barrel
look on the throttoe body and back the idle adjusting screw out the screw is a flat head some times it is good to take it out and cleane the end off carbon builds up on the scew hope this helps
2. One to hold the light bulb and one to turn the ladder.
The door panel is simply clipped on. There might be a screw you need to take off on the door handle, but I cant remember. Just use a long flat-head screw driver to pry the door panel off, and then you can use your hands to ease the rest of the clips out. Be careful, those clips are old and very easy to break.
If you mean the rear ones you have to remove the rear light clusters,easily done by 2 clips inside the back of car[bit awkward to clip out but with a scew driver ok] Then just un clip the bulb holders and change the bulbs. Just push back into place.
start by locating the bend in the rim then use a spoke tool or a flat scew driver losen the spokeson the side of bend and tight others usally u can get it pretty straight by eyeing it. but the easiest why is just take it to a local bike shop and cost some were between 10-20 $$ depending.