j.h. van tassel
Is it possible to change Ford EA fuel injection carburettor to normal carburettor?
you have to have a carburettor to mix the air and fuel correctly in order for the engine to run
michel faraday
carburettor prices vary with different carburettors.but you cannot fix a cracked carb.u need to replace the carburettor
Strip the carburettor down, soak the parts in carburettor cleaner, blow out all orifaces with filtered compressed air.
The carburettor is what mixes air with fuel, it is required for the fuel to actually burn in the engine, there arn't advantages, it is a neccessary peice of kit.
A similar carburettor and engineering skill.
Buy a manual from the autopart store.
It is in the inlet to the carburettor. Remove the fuel line at the carburettor and then the large nut (1 inch). Remove the filter and be careful not to lose the spring.
Normally directly before the carburettor
It's on the intake side of the cylinder(s).
To set the Jetex carburettor on your Lambretta, start by ensuring the carburettor is clean and properly installed. Adjust the main jet to the desired size based on your engine modifications and performance goals. Fine-tune the air-fuel mixture by turning the mixture screw, usually located on the side of the carburettor, until the engine runs smoothly at idle. Finally, perform a test ride to check for acceleration and throttle response, making further adjustments as necessary.