The temp blend door actuator is broken.
The seal is shot, time to replace the water pump. Do not let engine over heat!
time for an oil change
More than likely a stuck horn relay.
It takes a few minutes of run time for the compressor to warm up the discharge gas, which is the heat source.
You hear people say this all the time: (check the bands to make sure they are tight enough) Well, A 1991 Chevy anything does not have "Bands". So the answer is: NONE.
Wich marks can u use to set it on time if the marks are erased
Certainly. As can a straight iron and curling iron. The heat from the blow dryer can make your hair frizzy and over time, cold cause permanent damage
Check the Horn wiring and if this is good then replace the horn.
In the Heat of the Night - 1988 Time of the Stranger 3-7 was released on: USA: 5 December 1989 Netherlands: 16 August 1991
It depends on what your heat source is. An electric or petroleum fired forced air furnace will blow high volumes of air that is much hotter than 72 degrees Fahrenheit (perhaps as high as 90-100 degrees) for short periods of time. A heat pump, however, will generally blow air that is nearer the set temperature at lower volumes and for longer periods of time.
Click set while radio is off an use the volume and tune for the hour and minute.
Your hair will be dry, damaged, and broken off. Its very unhealthy. Its just like straightening it all the time. Try air dyring or low heat.