0
What else can I help you with?
What would cause a Daewoo lanos to burr loudly when you push your clutch in.. what could it be?
Sounds like the thrust bearing is worn, gearbox out to change this, may as well change clutch at same time.
How do you change a clutch cable on a Daewoo nexia?
Daewoo nexia is with hidrolic sistem for clutch. There is no cable
How do you fit clutch cable?
How to fit clutch cable on a daewoo cielo
How do you tell if a clutch is going on a Daewoo matiz?
Clutch wear can be told by noticing no wheel spin when the engine revs are higher than they should be for the speed you are going. Make sure your foot is off the clutch. Thrust bearing wear on the shaft make a sound when you engage or disengage the clutch. You may also feel the oddness in the pedal when the noise occurs.
Does clutch used in excavators?
yes,Hitachi wh o4&05,daewoo dh 5 have a clutch
How do you bleed the clutch in a 95 Daewoo cielo?
there dry clutch's, run a cable. no fluid. .:. you can't bleed it. :)
How do you change the clutch on a Daewoo Lanos 1.4?
you take it to an experienced mechanic...
How do you change a front wheel bearing on a 99 daewoo nubira?
to change a front wheel bearing remove macpherson strut and press out bearings with a press, replace with press.
How do you adjust the clutch on a Daewoo lanos?
It might be similar to this? http://wiki.answers.com/Q/How_do_you_adjust_Daewoo_Matiz_clutch_cableIm going to try it on my daweoo cielo tonight
How do you replace wheel bearing on a Daewoo lanos?
To replace the wheel bearing on a Daewoo Lanos, first, lift the vehicle and remove the wheel. Next, detach the brake caliper and rotor, then remove the hub assembly by taking out the retaining bolts. After this, press out the old bearing and press in the new one, ensuring it's properly seated. Finally, reassemble the hub, rotor, caliper, and wheel, then lower the vehicle and test for proper function.
How do you change steering column bearing in Daewoo Lanos?
To change the steering column bearing in a Daewoo Lanos, first disconnect the battery and remove the steering wheel and airbag if equipped. Next, detach the steering column from the dashboard and remove any necessary trim pieces to access the bearing. Once exposed, pull out the old bearing and press in the new one, ensuring it is properly seated. Reassemble the steering column and reconnect the battery, making sure all components are securely fastened.
Were is the the ecu box on a 99 reg daewoo matiz se plus?
under dash driver's side next to clutch pedal and upwards
