The boiling point of the mixture is higher than the boiling point of pure water; this slows down the evaporation of the coolant.
Ethylene glycol mixed up to 50% with water, lowers the freezing point of the mixture, while remaining an excellent heat transfer medium. It protects the engine from either freezing or from overheating.
Gasoline doesn't go in a radiator. Radiator is used to cool a 200+ degree engine block. If mixed the better question is at what temperature does gasoline ignite.
Don't do that. This product contains sodium hydroxide (lye) and glycol ether, and glycol ether is combustible. Mixing lye and sulfuric acid produces an exothermic reaction - which is probably hot enough to ignite the glycol ether. And it would throw stuff all over the place. Result - flaming solvent dispersed wildly.
It depends what it is mixed with.
It gets mixed in the enzymes
NO! That would be dangerous. Cars' coolant systems are pressurized, so if you open the radiator cap while the engine is running, it will spray HOT radiator fluid (water mixed with ethylene glycol, usually) all over you, and sometimes drain the radiator of coolant.
Phosphate-free ethylene glycol coolant mixed 50/50 with water
Toyota Long Life coolant. Pricey. Any brand name ethylene-glycol based coolant, mixed 50/50 would be OK.
When mixed with coolant in the radiator it tends to look like a chocolate milkshake.
The 1999 Wrangler is equipped with an overflow tank. The amount iof coolant to add to the radiator is slightly less than 2 gallons. Be sure to use either a 50/50 coolant (pre-mixed with water) or a gallon of concentrated coolant mixed with an equal amount of water. You will have about 3/4 inch of coolant left in the container when the radiator is full. The overflow tank is there to hold coolant when the radiator gets warm and needs to expell some of the coolant. So just fill the radiator with coolant. You'll know when it's full.
Any Ethylene Glycol based coolant mixed in a 1:1 ratio with water. Prediluted means it is already in the correct ratio.
Yes, Ethylene glycol and Propylene glycol are very similar chemically, therefore, can be mixed without any bad consequences for the engine.
A Ethylene glycol antifreeze coolant should be used (Mopar coolant) and mixed with 50/50 with distilled water. Another coolant that is pretty good is the Zerex G-05 antifreeze (approved by Daimler-Chrysler).
Sounds like you may have a bad head gasket
You don't, unless you are flushing the system. Use distilled water and add it to the coolant recovery bottle - and it needs to be mixed with coolant.
One gallon and antifreeze and one gallon of water are needed to make coolant. They are then mixed together in a large bucket and then pour into your vehicles radiator.
Yes as long as it is mixed 50-50 with coolant/antifreeze.