Without being able to diagnose, I would say you may have an intake manifold vacuum leak. This could be resolved when the engine heats-up, expands the parts and the vacuum leak disappears. If it is a newer engine with electronic engine controls, the sensors take over when it is warm and will control the fuel flow to off-set the vacuum leak and allow it to run (crappy and very fuel-inefficiently, but run nonetheless). Again, this is only one possibilty in a pile of possibilities...Have it looked-at and find-out for sure!
i have a 1988 Ford Bronco XLT 5.0 4x4. The truck will start and idle for about 15 to 30 seconds then acts like it has no fuel and dies.
throttle body or idle air control value
A Ford Escort might not idle properly if the throttle position sensor is not functioning properly. This part is a plug in that is on the side of the carburetor (throttle body).
It could be the idle control P1507
Your idle air control valve may be dirty or clogged, the fuel filter may need changing or the rpm is set to low.
If a Zx2 shudders and dies out at stops and idle, the idle might need adjusted. If the idle is set too low, it will not maintain enough power.
The idle control valve is mounted on the side of the throttle body. Carbon building up in the valve will cause the engine not to run properly.
It could be related to the idle air control valve. I don't know what the sensor is called but if your car's valve doesn't work it doesn't get air into the engine properly while idle so the car dies eve if the engine sounds like it's turning smoothly. Hope that helps.
The car was staying idle.
Generally speaking, modern computer-controlled engines don't have any idle adjustments. It's all supposed to be controlled by the computer. If the engine won't idle properly, then there's something wrong and it needs to be checked out by a mechanic.
I would say if it run ok cold but dies or has bad idle after warming up very possible the coil packs are going bad
The engine idle is controlled by the ECU, and is not adjustable. If the engine is not idling properly, either too fast or too slow, take it to a shop and have them check the OBDII codes.