Actually it can be used as a diode, but rarely is. Just connect the grid and plate together and it has been reduced to a diode. There are also certain circuits that use the cathode and grid as a diode, while also obtaining an amplified output on the plate.
rectifier is used to resist the current likewise in bridge wave rectifier ,the inductive load is used to resist high amount of current because in bridge wave we cannot resist the current by using rectifier ..so we are using inductive load here
such a control rectifier that control or rectifier single phase. for that purpose we used SCR that is called single phase controlled rectifier.
yes, diode can be used as rectifier diode to convert ac to dc
Because , the high voltage can destroy the diodes used in the rectifier .
rectifier is not used because of damaged of problemAnswer.Because there's no need for that since the lamp on your bicycle can still work on the induced AC power.
The twoends of a center tap transformer cannot be used without a rectifier.
With a diode tube you have no control over the current flow and it can only be used as a rectifier, where the triode consist of a control grid, to control the flow of electrons that will reach the anode, this make it possible to use the triode as a amplifier, compared to a transistor the control grid have the same function as the base of the transistor.Advantages?Over tetrodes and pentodes:1. Operation at higher radio frequencies,2. Lower noise figures,3. Simpler circuitry and only one power supply.
rectifier is used to resist the current likewise in bridge wave rectifier ,the inductive load is used to resist high amount of current because in bridge wave we cannot resist the current by using rectifier ..so we are using inductive load here
yes ofcourse diode can be used as rectifier but it's an uncontrolled rectification.
such a control rectifier that control or rectifier single phase. for that purpose we used SCR that is called single phase controlled rectifier.
yes, diode can be used as rectifier diode to convert ac to dc
Rectifier is used to convert alternating current to direct current.
You cannot use a rectifier to go from DC to AC. You need an oscillator.
a tetrode is used when you need a screen grid tube, but a suppressor grid tube can't be used.OK, but the question was "why use a tetrode instead of a triode?"So, the answer...1. A tetrode has a higher voltage/power gain than a triode.2. A tetrode has less anode-grid feedback capacitance than a triode, and can operate in common-cathode radio frequency circuits without the neutralisation (or other corrective circuitry) that is needed by a triode.
such a control rectifier that control or rectifier single phase. for that purpose we used SCR that is called single phase controlled rectifier.
Because , the high voltage can destroy the diodes used in the rectifier .
A diode is used to stop the negative voltage swing in an AC signal, so you only get the positive portions.diode-rectifier