Want this question answered?
When the actual flow (Qa) is greater than theoretical flow (Qt) in a reciprocating pump it is negetive slip.
The theoretical loads being calculated should be higher than the actual loads that will be used in reality because the weight capacity of a structure, vehicle etc. should exceed the amount of weight it is intended to actually hold. This is true for any type of load, driveshafts, shirt buttons, whatever.
In case of vapour compression cycle (VCC) the COP is given by (desired effect / work input). in the other words it can be defines as what we want and what we are paying for that... so in VCC the paying amount is very less as due to low temperature difference that why its value is more than 1. but in case of vapour absorption system the COP is given by (heat taken by evaporator/ heat given to generator). the heat input taken by evaporator is less as compared to heat given to generator.. that why its COP is less than 1......
Every real machine is subject to forces that reduce output. These include actual forces such as friction, or human controlled forces such as imperfect machining. This reduces the output to less than the ideal.
It is almost inevitable that some energy is lost.If the engine produces heat, as in a gasoline engine, there is a theoretical limit - that of the theoretical Carnot engine - which is itself less than 100%. For example, if the ambient temperature is 300 kelvin and the engine works at 900 kelvin, the theoretical efficiency is 66.666... percent. But the real efficiency would be even less than that.
The actual yield is less than the theoretical yield.
The percent yield is the ratio of the actual yield to the theoretical yield. A mole ratio is a conversion factor derived from the coefficient of a balanced chemical equation interpreted in terms of moles.
No, competing side reaction is a reson why the actual yield is more than the theoretical yield.
Theoretical= calculated
Mahit Nahi
yes
Actual compensation will always be less than theoretical payouts. For example, it the posted payout is 50%, the actual payout will be somewhere closer to half of that amount, or 25% actual payout.
If actual yield is higher than theoretical yield then it means the required products contains impurities.
Because the baby goats aren't allowed to swim in the ocean. =(
It is always less than 100% Theoretical machines can have efficiencies of 100% but in practice there is always some energy loss Efficiencies of more than 100% are not allowed by the laws of thermodynamics!
Theoretical calculations take into account many factors that in fact should not be involved
Actual yield is always less than theoretical yield because: 1) Much amount of product is lost in experimental techniques i.e. filtration, evaporation etc. 2) Much amount of product is lost in energy i.e. heat energy.