answersLogoWhite

0

chk the ground wire on the harness to the fuel pump...........

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

How do you install fuel pump for 1998 Jeep Cherokee Limited?

The fuel pump is in the gas tank. You have to empty the tank and drop it in order to get to the fuel pump. It's a bum deal; not to mention slightly dangerous. Be sure to disconnect the battery as to avoid any possibility of sparks. Good luck!


How do you remove fuel pump on 1994 caprice?

Empty the fuel tank, disconnect your battery (+ and -), take down the tank, disconnect the connector of the sender and the 2 fuel pipes. Then unscrew the sender assembly out of the tank. You have the pump, the strainer and the level sensor.


What is the duration of The Empty Gun?

The duration of The Empty Gun is 1800.0 seconds.


What actors and actresses appeared in Battery Empty - 2011?

The cast of Battery Empty - 2011 includes: Vijay Budekar


Does a fully charged battery weigh more than an empty battery?

No, a fully charged battery does not weigh more than an empty battery. The weight of a battery remains the same regardless of its charge level.


What is the duration of Empty TV series?

The duration of Empty - TV series - is 1800.0 seconds.


What type of water can you fill in a empty car battery?

De-ionised water Distilled water is recommended if the battery just needs topping off. Sulfuric acid if the battery is empty.


What is the duration of The Big Empty short film?

The duration of The Big Empty - short film - is 780.0 seconds.


Where is the pressure release valve for the fuel line of a 1990 Buick Skylark?

fuel pressure release valve ? Just disconnect wire harness from tank or remove fuse to fuel pump then start and run engine until it runs out of fuel in line then continue to try to start for 20 seconds then disconect battery and service pump or injectors as the fuel system is now empty of fuel and pressure.


How do you charge a motorcycle battery with a car battery?

You must get a couple of so-called jumper cables. The cables have strong clamps on them and are designed to be clamped to the battery terminals. Attach the black cable to the negative terminals of the motorcycle and car battery first. Then attach the red or positive cable to the positive terminals of the motorcycle and the car battery. In case your motorcycle battery is empty, you can now start the bike from the car battery. Disconnect the cables in reverse order, beginning with the red cable. The motorcycle battery will not be charged much by the car battery but the bike can be jump started by using this method.


What can you do if your tablet won't turn on?

Because the battery is empty .... or its just broken


How do you empty a water bottle in 2 seconds?

Chop it in half with an axe. Carefully.