If you are able to unlock the doors but not lock them I would suspect the " door lock " relay located in the jack storage compartment . There are relays for door unlock / door lock / interior lamps / driver door unlock / and trailer park lamps in the relay box. The door lock relay is one of the larger relays , located in the bottom left position ( looking at the picture ) good luck !
If you cannot lock the doors , but you can unlock them with the remote or keypad - I believe there is a door lock relay in the jack storage compartment (among 5 relays) I believe it is one of the two large relays and is located on the left at the bottom. If you can't lock or unlock the doors with the keypad or remote - some 1995 to 1997 Ford Explorers had a problem with the RAP (remote anti-theft personality module) being damaged by static electricity causing the keypad and remotes not to work. The repair involved installing a "redundant ground" on the passenger seat(s) Check with a Ford dealer
No , just to lock or unlock the doors
Press the 3/4 button within 5 seconds of unlocking the drivers door with the keypad and all other doors and the liftgate will unlock ( at least that's the way it is on my 1995 Ford Explorer XLT )
I have a remote that locks and unlockes the doors. Could you plesase explain to me how to programm it plz
You should be able to get in the Explorer , lock the doors if you wish , and then start the vehicle . That's what I do on my 1995 Explorer XLT
You can unlock all the doors , liftgate and glass using the keyless entry keypad , but to actually get the rear glass to open you have to turn the handle on the liftgate Enter your personal code or the factory code to unlock the drivers door and then push the 3/4 button within 5 seconds to unlock the other doors and liftgate
have you checked to batteries in the remote?
i know what it is its remote start
Keep pressing the door until you see the keypad. When you see the keypad, press 132211See related link below for screenshots.
Keep pressing the door until you see the keypad. When you see the keypad, press 132211See related link below for screenshots.
Yes.
# Sit in car, doors closed. Electronically unlock all doors using the power door unlock switch on the driver's door. # Insert key into ignition switch and turn from OFF to ON 8 times within 10 seconds with the 8th time ending in the ON position. (5 times on some models) # The doors should lock and unlock by themselves to signal programming mode. # Using your remote: lock the doors.