It's common to put arcing horns on the HV side of a power transformer to short out voltage spikes arriving from lightning strikes along the line.
In general, you can install a wattmeter on the primary or the secondary side of a transformer (it depends what you are trying to measure). But if you are conducting an open- and short-circuit test (to find the transformer's losses), then the wattmeter is connected to the primary side because you want to measure the total (primary + secondary) losses and that is only achievable from the primary side.
Yes, but it's usual to have fuses on both sides of the transformer.
the difference between a step up transformer and a step down transformer is that, in a tsep up transformer, the voltage secondary is greater than the primary side but in a step down transformer, the voltage secondary is lesser than the primary side
The 'input' side of a transformer is called its 'primary' side, whereas the 'output' side is termed its 'secondary' side. The ratio of its secondary to primary voltage is equal to the ratio of the number of turns in the secondary windings to the number of turns in the primary winding. So if, for example, a transformer's secondary winding has twice as many turns as its primary winding, then the secondary winding will produce twice the voltage applied to the primary winding.
high voltage side call primary
This isn't the case. You can have aluminium or copper on primary or secondary side of a transformer.
In general, you can install a wattmeter on the primary or the secondary side of a transformer (it depends what you are trying to measure). But if you are conducting an open- and short-circuit test (to find the transformer's losses), then the wattmeter is connected to the primary side because you want to measure the total (primary + secondary) losses and that is only achievable from the primary side.
Yes, but it's usual to have fuses on both sides of the transformer.
The terminals H1 and H2 an a transformer indicate the primary side of the transformer. The secondary side is usually identified as X1 and X2.
the difference between a step up transformer and a step down transformer is that, in a tsep up transformer, the voltage secondary is greater than the primary side but in a step down transformer, the voltage secondary is lesser than the primary side
For the 120/24V transformer, the primary side is around 50ohm, the secondary side is 2~
The 'input' side of a transformer is called its 'primary' side, whereas the 'output' side is termed its 'secondary' side. The ratio of its secondary to primary voltage is equal to the ratio of the number of turns in the secondary windings to the number of turns in the primary winding. So if, for example, a transformer's secondary winding has twice as many turns as its primary winding, then the secondary winding will produce twice the voltage applied to the primary winding.
high voltage side call primary
yes........ we can short circuit the other side of the winding wen the primary is excited.... but we shouldn't apply rated voltage to the primary.. this method is used in the short circuit test of the transformer to find the parameters of the transformer.....
A: The only way can be possible if the transformer is an isolation type. Yes, you can put the input into the secondary side. This will create a step-up transformer.
A DC voltage added to one side of a transformer has no effect on the other side.
You are probably describing a transformer. The 'high voltage side' of a transformer is the winding with the greatest number of terms. It could be the primary or the secondary winding.