its the switch
but i can use the switch when i start it with the ebrak on! it functions properly until the ebrakes off. then its just highbeams all the time from there. i have to actually shut off the car and start it with the ebrake on to do anything. if it was the switch wouldnt it not work properly ever?
In some cases you can disconnect the plug on the ebrake switch. I was able to access it by pulling back on the ebrake side cover.
If you lift your ebrake handle one notch, it will not engage the brake, but it will turn off your drl's. Or you could always pull the fuse.. :)
Put it in gear
what knds of car do yoy have .
with your ebrake cable.
Easiest way, pull the fuse from under the hood. It should be labeled. You'll probably lose traction control too, and ebrake/tc/abs lights may stay on all the time.
the wire needs ground to function. Connecting it to the ebrake allows it to ground so just connect the video wire to any ground and it will function as if it was connected to the ebrake
usually this is done at the ebrake itself. there are two wires going to it.
press your ebrake one or two clicks and leave it on
put in reverse and go about 5 then slam it into drive and gas it to the floor or u can use the ebrake and go half way so you dont burn out the transmission and make sure that your ebrake is fully tightened other wise it wont work
in the center console,near the Ebrake and shifter there is a button labeled ETS. that controls the turning on and off of the track control. u can maualy turn track control off by pressing this button.however after shutting off the car and restarting it,it will go back on.
Right next to the ebrake there is a pop off plastic door. There are your fuses.