Every lamp and every appliance in your home has a rated power which can only be achieved at its rated voltage. These values are shown on an appliance's nameplate or is printed on each lamp -e.g. your lamps may be rated at 100 W / 230 V. It is, therefore, essential that every appliance is subject to its rated voltage of 230 V. This can only be achieved by connecting them in parallel with the 230-V supply. (For N America, read '120 V' for '230 V')
A secondary advantage is that, with a series circuit, only one appliance has to stop working, and all the other appliances would stop working too.
series and parallel
You do not build a series circuit in your home. The only series circuits are the circuits that go through circuit breakers, light switches, and relays. Electrical and electronic devices use internal series circuits but those are the only ones people build. No one builds series circuits for house wiring. Electrical outlets are connected with parallel wiring.
In the electrical trade there are three types of electrical circuits. They are series, parallel and series - parallel. All three types are used every day in building construction and home construction.
I'm not sure they're "voltages" but if you're talking about the circuits, then the two types are series and paralllel.
paralel circuits
Wind circuit is not a type of home circuit. The common types of home circuits are electrical circuits, lighting circuits, and dedicated circuits.
Parallel circuits are used when there are many electronics on the same circuit, such as Christmas lights, for example. If they were on a series circuit, if one bulb went out all of them would go out. In your home, parallel circuits allow you to turn any electrical device on or off, independently of the others.
If a home were wired in series, every light and appliance would have to be turned on in order for any light or appliance to work.Because people dont like it
The most common of all circuits used in industry and around the home is the parallel circuit. In industry all MCC controls are in parallel with the supply distribution and around the home all lighting circuits are in parallel with the supply distribution panel.
They're connected in parallel, this is so that everything connected to the circuits will receive the same voltage. Also, if everything was connected in series, if one of the components died, everything would be dead (think of christmas lights)
It is very convenient that the store is located right next to my apartment.
The majority of the circuits in your home are run on 15 amp circuits.