0
Why armoured cables has less bending radius than lead covered cables?
Wiki User
∙ 13y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What is bend radius of power cable how can you calculate the bend radius of 3c xlpe 240sqmm armoured cable having diameter of 100mm?
The radius of the curve of the inner edge of the bends shall be at least 6 times the external diameter for armoured cable.
What is the bending radius of HT cable?
15 D
What is the Maximum bending radius for sheet metal forming?
I believe you want to know the MINIMUM bending radius of sheet metal. The maximum bend would be 180 degrees.
What is the minimum bend radius for the diameter of cable?
It depends on the cable. 0 to 5000 volts the minimum bending radius is 6 x diameter of the cable. Above 5000 volts the minimum bending radius is 8 x the diameter of the cable.
How do find a radius of a bend?
For Unshielded cables, it will 8 multiplies cable diameter and for shielded cables, it is 12 multiplies the cable diameter. However, the smaller the bend radius, the greater is the material flexibility.RegardsKelechi
What is the bending radius of a cable?
Typically, wires have a bend radius of 10 times the diameter of the wire. Measuring the inside. This is basically to prevent injury or changes in impedance at the bend. Also note that the tighter the bend can damage the insulation in coaxial or triaxial cables and cause lower dielectric strength between layers. Best to install cables where ripples don't form on the surface and moderate force is recommended. MIL-W-5088 has more information.
Why springback in bending depends on yield stress elastic modulus sheet thickness and bend radius?
Every bending mechanism gets governed by the simple bending equation M/I=F/y=E/R
What is the minimum bend radius for copper cables?
4 times the diameter of the cable
What was hurricane katrina radius?
What area was covered by the eye of Katrina.
Is Armored cable can be bent tighter than the recommended turning radius without causing damage to the conductors?
In my experiences with armored cables such as MC,HCFC the bending radius of the conductor inside is much smaller than the radius you could bend the armored casing. in other words the clad casing is going to break Which could potentially damage the conductors inside and should not be used. As always electrical wiring is not a hobby and should be left to licensed electricians who follow NEC codes and local codes
Formulae for minimum formable radius on sheet metals?
You are really looking for minumum bend radius. Here are a few links: http://www.engineersedge.com/sheet_metal.htm http://www.thefabricator.com/Bending/Bending_Article.cfm?ID=52
What is the difference between elbow and bend in piping?
" All bends are elbows but all elbows are not bends." Infact, the pipe is bent to form an elbow. Elbows are pre-fabricated and are firm in design. There are issues with bends since the tickness at the bend radius reduces as we bend the pipe. Sharp bends are normally called Elbows. Bends typically have a minimum bending radius of 1.5 times pipe radius (R). If this bending radius is less than 1.5R, it is called Elbow. Reference to any international / industry standard need to be traced. 1.5, 3 & 4.5 R are the most common bending radii in industry.
