Adjusted too loose, belt is glazed over and worn out, replace it.
A belt drive is an alternative to a chain drive (as you would normally find on a bicycle or motorcycle). There are several types of belt used in belt drive systems including V-belts and toothed belts. The more common is the V-belt. A cross section of the pulley used shows that the belt runs in a V-shaped groove. Washing machines, older cars, and machinery use this type of belt system. The toothed belt is normally wide and flat with teeth on the inside to prevent slippage. Harley Davidson motorcycles use these, as do super-charged engines in cars.
A industrial raw edge cogged belt is a high-performance belt used in applications where slippage or failure must be avoided. Made of rubber with cogs or nubs running all along the inside of it, the industrial raw edge cogged belt is designed to interlock with grooves or notches on the drive pulley. This interlocking design allows the industrial raw edge cogged belt to operate without slippage even at high engine speeds. Much like a chain and a sprocket, the cog belt can turn engine accessories without the fear of failure or slippage traditional rubber V-belts - or fan belts as they are most commonly called - are known for.
V Belt and Serpentine Belt.
Sleep and creep does not take place for the v-belt. compare to flat belt it will be very less.
The accessory drive belt and the timing belt.
Replacement for a "V" belt to drive engine accessories i.e. p.s., alternator, a/c compressor etc. A toothed belt offers a better grip and "wrap" than standard "V" belt
RP126520X Mower V-BeltRP138255 Drive Belt
No, the serpentine belt is used to drive more than one thing and tension is automatically adjust by way of a spring loaded idler pulley. Normally it will drive the alternator, power steering pump, & A/C compressor. A drive belt normally drives only one thing and tension is manually adjusted. A serpentine belt is wider that a drive belt and is not a V-Belt like a drive belt.
My personal CR-V is a two wheel drive version. There are versions that are built as All Wheel Drives (AWD), but there are no "true" 4-wheel drive CR-V's. You cannot manually place your AWD into 4WD. AWD is designed so that it only operates when the on-board-computer senses wheel slippage from the front drive wheels and then automatically engages the rear wheels. When it no longer senses slippage the AWD feature is deactivated.
how to replace drive belt on a 2005 ford escape XLT 3.0 V-6
What do you mean by drive belt. If your talking about the serpentine belt, it should have an auto tensioner. Same goes for the timing belt. There is no adjustment. If the belt is loose then it needs to be replaced. ed724
A-sect V belt 1/2 by 78 part # 954-0461