it's probably a block wall and it's solid concrete above the window and door openings
try a masonry bit in your drill
You probably have to drill out some rivets.
No they cant
you cant
Take the door panel apart remove the torks bolts at the bottom holding the window motor in. Take a drill and drill out the three rivet holes to remove the motor. You will then need to buy replacement bolts to reinstall unless they come with the motor. I had to do this yesterday and rebuilt the motor. (That will test the patients.) I cant seem to find where they sell them in my area.
We cant drill in America because we do not need the polution the econemy would drop more and that is just what we say.
Put the trash can on the seesaw then jump on the other end. Then use the trashcan to jump onto the window's ledge. Bada Bing! Your in school.
You Cant.
A lot of money that i cant afford
Use an air wrench. If it is stripped than get a very large drill bit and drill it out.
If you cant find an openening large enough then you can always drill a hole and place a grommet in the hole and then run the wire through the grommet. Hope this helps.
u cant means cant so dont ask it
shoot farther away till you cant make it anymore