Want this question answered?
It would be unity, or 1.0. Since the voltage in a DC circuit does not vary with time, there can be no phase displacement of the current waveform, and therefore the current could not lead or lag the voltage waveform.
Volt-Ampere Reactive. It is the reactive component of power when the Power Factor is less than unity (1.0). It is usually measured in KVAR - 1000's of VAR.
DNA is the molecule that is responsible for unity and diversity of life .
You have to know the current carring capacity of the line and the power factor to make the calculation. Watts = Amps x Volts x p.f If p.f is unity, then watt = Amps x Volts
It's not.
For an Ideal gas(steam), the compressibility factor is obviously unity under all conditions whereas for real gas(steam), the compressibility factor may be less or more than unity based on the actual conditions. With best regards, elavazhgan.
Power factor can be unity. If the load is purely resistive, then the load current and supply voltage are in phase, and the load will have unity power factor.
Power factor cannot exceed unity!
There is no disadvantage of unity power factor, because at unity power factor all the electrical power is efficiently utilized by the the load, and at lagging power factor some power is lost in the load's magneticfield.
The Hour of Power - 1970 The Unity Factor was released on: USA: 5 May 2013
when voltage n current r in same phase(it happens when load is resistive) ,the power factor which denoted by "fi" is 1 .this condition is known as unity power factor
power factor depends on the load being fed if the load is entirely resistive power factor will be unity ..if the load includes an inductor or capacitpr due to phase displacement between v and i the pf will be lag or lead respectievly
the Nile
Unity power factor has a value of 1.0. This means the current and voltage waveforms are in phase. This is only possible if the net load is non-reactive (resistive). If the load is either capacitively or inductively reactive, the power factor will be other than unity. If an inductively reactive load such as a motor is offset by a capacitively reactive load such as a PF correction capacitor, it is possible to acheive a net load that has unity power factor. Some loads, such as resistance heaters, are intrinsically non-reactive, and present a unity power factor.
all of these were factors hindering unity
all of these were factors hindering unity
"Unity"