0
Conductance is ignored in short circuit studies because the inductance of the line is the dominant value. Conductance may not be ignored in stability studies.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is the basic parameters of transmission lines?
the basic parameters of transmission lines are R,L,C and G...........
Why 22kv 11kv 33kv 132kv 220 kv are standard transmission voltages in transmission lines why not 20kv 10kv etc?
Its just a matter of standard. In my area, for instance, we use 13.2 KV for distribution lines, and 69 KV / 138 KV for transmission lines.
What is the sizes of cable for transmission lines?
336 776 and 795
What is the inverse of resistance?
The inverse of resistance is conductance.
What is stomatal resistance?
The opposite of stomatal conductance of course!
Why leakage conductance is neglected in overhead lines?
The shunt conductance is due to leakage currents flowing across insulators and air. As leakage current is considerably small compared to nominal current, it is usually neglected, and therefore, shunt conductance is normally not considered for the transmission line modeling.
What are the 4 primary constant and secondary constant of transmission lines?
resistance (R) inductance(L) capacitance(C) shunt conductance(G)
Disconnecting transmission lines 96 jeep?
You can disconnect the 1996 Jeep transmission lines with a 9/16 open end wrench. Be prepared for transmission fluid to come out of the transmission lines.
How can you replace the lines that carry transmission fluid to the transmission?
if you are asking about the cooling lines for the transmission that connect to the radiator, its easy. first disconnect the lines from the radiator (2 lines, usually on the bottom opposite the radiator outlet) then disconnect the lines from the transmission. remove the brackets holding them on, then remove.
What is the major material used in constructing transmission lines?
The major material used in the construction of transmission lines is aluminum alloy. Steel is also used to reinforce the lines. No insulation is used for overhead transmission lines.
What is the basic parameters of transmission lines?
the basic parameters of transmission lines are R,L,C and G...........
Where do the vacuum lines run from and to on ford escort automatic transmission?
There are no vacuum lines running to the automatic transmission.
How replace 2000 Jimmy 4x4 transmission cooler lines?
The transmission lines on a 2000 GMC Jimmy 4x4 are replaced by disconnecting the lines at the radiator and then the side of the transmission. They are then removed from the bottom of the vehicle and new lines put in place.
Why is conductance G?
Conductance is an opposition of Resistance and it is denoted by G. It is given by the relationship G = 1/R . In past the unit of conductance was (mho) which is opposite to (ohm). But these days the unit of conductance is Siemens which is denoted by 'S'.
How many phase are there from transmission line from Oregon?
AC transmission lines are 3-phase, DC transmission lines don't have phases. It doesn't matter where they are from.
Will a fully charged new battery have a low conductance reading?
No it will have high conductance
Where are trans-cooler lines on a 2002 GMC Sierra 5.3L?
transmission cooler lines runs from transmission to the radiator
