0
Why did my car Clunk then loose speed and start shuddering even when idle?
Wiki User
∙ 14y ago
Check your engine mounting and also check your coils, sounds as if one of them may have blown . Same thing happened to me .
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What causes shuddering while driving a fiesta 1995 1.1lx?
The shuddering could be caused by several things. Check the front end parts on the Fiesta to start with. A loose or worn part is the most likely cause of the problem.
There are times when my 2004 4-Runner will not move when put into drive. Then there will be a pop or clunk in the rear end and the vehicle will start to move forward.?
sounds like transmission problems( not moving in drive) and u-joint problems(pop or clunk
When you come to a stop something in your front end seems to be loose or pop out of place and then back into place when you resume accelerating what could this be?
Have the drive shaft u-joints checked. When u-joints start to go bad, you will usually hear a clunk when coming to a stop and then again when you accelerte.
Why would 99 jeep grand Cherokee start to clunk when putting it in drive and check engine light is on?
probably u-joints on driveshaft
If you have colon cancer do you start to loose a lot of weight?
If you have colon cancer do you start to loose a lot of weight?
Car give a clunk sound and wont start but everthing turns over?
check the fuses to the fuel pump and the fuses to the fuel injectors if you have injectors.
Why do you always have to jump start a 1995 Honda Accord EX V-tec 5-speed?
Weak battery? Loose or corroded battery cables? Bad starter?
What is jamal gota?
It is the medicine of loose motion if you will it you will start to have loose motion
Can loose wires cause a car battery not to start?
Certainly, a loose wire on the car battery can cause the car not to start.
What are the symptons of blown engine in your car?
The engine would probably be seized up. The starter would only make one clunk each time you turn the key to start.
What would cause a no start condition with a caterpillar 3406-e engine?
Engine speed sensor faulty. Dead battery or batteries. Loose or dirty battery connection. Dead spot on starter.
How do you calculate your speed when we start to run?
Your speed is zero when you start to run, then it gets higher.
