Want this question answered?
This is the most common type of home electrical wire that is installed for general purpose electrical circuits, also known as Type NM or Non-Metallic sheathed cable made up of at least one pair of insulated wire conductors and one bare wire used for the ground conductor. The ground conductor is bonded throughout the home to maintain a contiguous grounded system which originates back at the Main Service Panel.
It just means that the bare wire is insulated by a non-conducting coating. In home wiring the typical circuit has a black wire (Hot), a white wire (Neutral) and a bare wire which is ground.
So that you will know it is the earth ground wire and not the neutral wire or the hot wire. The neutral white wire is not necessarily connected to the same place as the earth ground wire. It is also bare because it does not matter if it touches a metal exterior since it is supposed to be connected to that anyway for safety. Both the neutral white wire and the hot black wire are insulated so they will not normally short to the bare ground wire.
In house wiring it's typically a bare copper wire. It may occasionally be green.
12-3 romex is twelve American wire gauge, three conductor cable (1 black hot conductor, 1 red hot conductor and 1 white conductor normally the grounded conductor, but can sometimes be used as a hot must be marked; plus there is a bare paper covered ground wire) designed for housing and can carry twenty amps of current. (It can actually carry more but the NEC (National Electrical Code) requires it to be on a maximum 20 A circuit breaker. It is only 20 amps if it is copper. 12/3 also comes in aluminum, if so it is only rated for 15 amps. This wiring is used for split circuits (common in kitchen receptacles) and also used in 3-way switching.
A bare conductor is a conductor that does not have any type of insulation covering it. Insulated conductors (also known as coated) have a covering that protects them from outside sources.
The electrical terminology of a wire with no insulation on it is a bare wire.
ECC stands for Earth Continuity Conductor. It is a grounding component of the electrical system. An ECC can be a bare conductor, a single conductor or a part of a multi-conductor cable.
uncovered conductor such as insulation ,that is said to be bare conductor.
The bare conductor is about 1.05 lb per foot. Insulated wire weight varies by type of insulation.
This is the most common type of home electrical wire that is installed for general purpose electrical circuits, also known as Type NM or Non-Metallic sheathed cable made up of at least one pair of insulated wire conductors and one bare wire used for the ground conductor. The ground conductor is bonded throughout the home to maintain a contiguous grounded system which originates back at the Main Service Panel.
No, the white should be approximately zero and the black approximately 110-120, assuming the "bare ground" refers to a bare conductor attached to electrical ground.
A 100 amp residential service requires a size #8 copper wire, it should be insulated in green.
A ground wire can be bare because it is not a current carrying conductor. It is at the same potential as all the rest of the metallic conductive objects that make up the electrical system that the ground wire is grounding.
There are several ways to "contain" electricity: 1. In a capacitor. A capacitor is a device which can store ("contain") a static electrical charge as potential energy in an electric field. 2. In a battery. A battery is a device which can store ("contain") electrical energy in the form of potential chemical energy either as a result of the original manufacturing process or by reversable means as in a rechargable battery. 3. In an insulated conductor (a wire). An insulated conductor, including a bare conductor in air, gas, or vacuum, contains electricity in the sense that it restricts it to flowing within the conductor only and not "escaping" elsewhere. Some other ways of "containing" electricity essentially constitute capacitors, such as a storm cloud capable of producing lightning. It's a stretch, but one might also consider a generator to "contain" electricity. In any case, be careful!
Voltages in that range do not use insulation around the conductor. They are bare conductors and use air and separation from one another for the insulation factor.
It just means that the bare wire is insulated by a non-conducting coating. In home wiring the typical circuit has a black wire (Hot), a white wire (Neutral) and a bare wire which is ground.