0
Why do chillingsworth wish to prevent Dimmesdale from mounting the scaffold?
Wiki User
∙ 11y ago
He thinks that Dimmesdale is going to tell everyone about him being Hester's husband.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What is the purpose of toe bar on scaffold?
The toe bar on a scaffold helps prevent materials and tools from falling off the platform and creating hazards for workers below. It also provides additional support and stability to the scaffold structure.
Can you prevent builders from erecting scaffolding on your property?
I am a scaffolder and you can stop them erecting scaffold on your property and stop them from projecting in to your air space I am a scaffolder and you can stop them erecting scaffold on your property and stop them from projecting in to your air space
What is a scaffold outrigger?
A scaffold outrigger is a horizontal extension attached to a scaffold frame to improve stability and support the platform. It helps to distribute weight and prevent tipping over by increasing the base area. Outriggers are commonly used in construction to enhance the safety and strength of scaffolding systems.
Can you tie off on a scaffold?
Yes, it is common and essential to tie off on a scaffold to prevent falls and ensure safety. Workers should use proper fall protection equipment, such as harnesses and lanyards, to secure themselves to the scaffold structure or a secure anchorage point. This practice is a crucial safety measure in construction and other industries where scaffolding is used.
Why the specimen should be dried before positioning and mounting?
Because it will change shape as it dries, so mounting it while it is wet would cause excessive stresses.
What do you do if your horse is to tall to get on to ride?
Well ideally you would be riding a horse that you could easily mount from the ground if you needed to. But as the horse is too tall, then you should used a mounting block or a step stool. Also it is better for a horses back to mount from a mounting block as it helps to prevent back pain in the horse.
What did Pearl Harbor do when the Japanese attacked?
Two answers to this (both are correct):1. To Destroy ships and planes that threatened their expansion efforts.2.The attacks was to prevent Americans from mounting a strong resistance to Japanese expansion.
What are the safety measures that can be taken for scaffolding?
The utility of a scaffold cannot be denied but the hazards which are associated with scaffold are also very common. This is the reason why we need to take precautions and safety measures during scaffolding.Anti Fall Protection System : it can prevent workers of being trapped in the building components in case a mishap happens, the person can be saved.Proper Erection : the structure must be solid and the method used for scaffolding erection must also be accurate.Safety Harness and Instructions : A safety harness must also be used and instructions should be given to the workers so that hazards can be prevented.
How do you replace the power steering pump on a 1983 Chevrolet truck?
Disconnect hoses at pump. When hoses are disconnected, secure ends in raised position to prevent drainage of oil. Cap or tape the ends of the hoses to prevent entrance of dirt. Install two caps at pump fittings to prevent drainage of oil from pump. Loosen bracket-to-pump mounting nuts. Remove the pump drive belt. Remove pump from attaching parts and remove pump from vehicle.
How to replace a fuel pump in a 1984 camaro?
CARBURETED MODELS # Disconnect the negative battery cable # Remove the fuel inlet and outlet lines.Use two wrenches to prevent damage to the pump and connections # Remove the fuel pump mounting bolts and the pump and gasket
How do you replace battery for e350 Ford van 2004?
Just simply remove mounting bolt and cables and remove old battery under hood. There may also be a battery under the passenger side mounted to the frame. You will need to remove the bolts holding battery case to frame. There are cables to prevent battery case and battery from falling. Once dropped done, remove both cables and mounting bolt for battery. Remove old battery and replace with new.
How do you reattach the side mirror on a 2000 Cadillac STS?
if you pull back the rubber seal on the front of the door, there's a hole to access the mounting screws for the mirror. You may need a special screwdriver to hold the screws to the driver to prevent them falling off the screwdriver as you insert the assembled screw driver and screw into the opening
