Electrical wires have plastic covering as when electric current flows through the copper wires and mistake we hold it so we may get an electric shock.
cuz its save
I believe you've managed to turn wires inside out. (conducting) wires are covered in insulating plastic. And it is done this way to prevent electrical energy from going where it is not wanted, such as into you.
yes wires is electrical panel
For safety precautions trailing power leads should be individually capped off. This can be done using a plastic tape designed especially for electrical wires or a permanent plastic cap.
No, practically all plastic is an insulator. An insulator does not carry any electrical currents. A conductor can carry a current. "What plastics are conductive?", you may ask -- see link below.
The chance of causing a break in the wire, or damage to the wire covering or coating. Also, it is not that you shouldn't pull on cables as in running electrical conduit in a building, it is common that the electrician has to "Pull"the wires through the conduit. The electrician generally knows how hard he can pull without damaging or chafing the wires.
Electrical wires have plastic covering as when electric current flows through the copper wires and mistake we hold it so we may get an electric shock.
as plastic is a good insulator of electricity.
Insulators are used to keep electrical currents in the circuit. If they do not follow the entire circuit, it would be a "short circuit".
The most common electrical insulator is the plastic coating on electrical wires. Hope this helps!
The pipes are PVC electrical conduits.
The most common electrical insulator is the plastic coating on electrical wires. Hope this helps!
Well plastic is a insulator which causes the electrons (also known as electricity) to stay in place. So wires are electrical conductors which means electrons to flow through it and since humans are "fair" electrical conductors it will cause us to get shocked from the electrical charges. Understand? :)
AnswerBecause, it is a good insulator and won't conduct electricity. It is also flexible.It coated by rubber or plastic
I believe you've managed to turn wires inside out. (conducting) wires are covered in insulating plastic. And it is done this way to prevent electrical energy from going where it is not wanted, such as into you.
think you take the plastic covering off and undo the wires and unbolt it
electrical conducters are madfrom metal because charges can travel through metal but rubber is a insulator so the charges cant get throught it so wires are covered with rubber for safety reasons so you don't get a shock.
on top of the engine, remove the plastic covering that houses the spark plug wires.